[PATCH] arch_timer: Move delay timer to drivers clocksource

[pgaikwad@nvidia.com (Prashant Gaikwad)]

On Tuesday 21 January 2014 02:10 PM, Daniel Lezcano wrote:
> On 01/21/2014 09:20 AM, Prashant Gaikwad wrote:
>> On Monday 20 January 2014 08:12 PM, Daniel Lezcano wrote:
>>> On 01/17/2014 07:36 PM, Stephen Boyd wrote:
>>>> On 01/17/14 05:40, Prashant Gaikwad wrote:
>>>>> Another requirement:
>>>>>
>>>>> We have 3 timers T1, T2, T3 used as wake events for 3 idle states C1,
>>>>> C2, C3 respectively.
>>>>>
>>>>> Rating of T2 is better than T3. If I register T2 and T3 both as
>>>>> broadcast timers then T3 will not be used. But ...
>>>>>        - T2 is not preserved in C3 idle state.
>>>>>        - T3 resolution is very poor (ms) and can not be used as wake
>>>>> event for C2.
>>>>>
>>>>> Possible solution, register only T3 as broadcast device and use T2 as
>>>>> per-CPU fallback timer.
>>>> We have the same situation on MSM. I've been thinking about proposing we
>>>> allow multiple broadcast timers to exist in the system and then have the
>>>> clockevents_notify() caller indicate which C state is being entered. The
>>>> broadcast timers would need to indicate which C state they don't work in
>>>> though.
>>> IMO, there are different solutions:
>>>
>>> 1. extend the C3STOP to C1STOP, C2STOP, etc ... and pass the idle state
>>> to the time framework where these flags are checked against. I don't
>>> like this approach but it is feasible.
>>>
>>> 2. use the generic power domain. When the power domain is shutdown via
>>> the cpuidle backend driver, it switches the timer.
>> I am aware of a way to attach idle state to GenPD where we enable an
>> idle state when that power domain is turned off but not the other way
>> where domain is shutdown via CPU idle driver. How do we do it?
>>
>> Even though we shutdown power domain via cpuidle driver this still has
>> to happen from CPU idle state, is that correct assumption? and we switch
>> the timer here. So we still need a way to switch timer from CPU idle
>> state. Hence the question remains is how to switch timers from idle state?
> You can effectively attach a power domain to a cpuidle state but that
> wasn't the point.
>
> What I meant is to create a generic power domain which maps the power
> domain of the idle state. When the power domain is shutdown, the
> callback of the genpd will switch to the timer.
>
> I can't give too much details because I am not used to this code but
> maybe it is a good solution for your specific case.
>

Somehow this is not mapping to my use case. We are using generic power 
domains with CPU idle states.