Re: 3.12: ethernet controller missing after resuming from suspend to RAM

[Francis Moreau <francis.moro@gmail.com>]

On 02/12/2014 12:58 AM, Rafael J. Wysocki wrote:
> On Tuesday, February 11, 2014 07:17:37 PM Peter Wu wrote:
>> On Tuesday 11 February 2014 12:42:37 Mika Westerberg wrote:
>>> On Mon, Feb 10, 2014 at 11:39:29PM +0100, Rafael J. Wysocki wrote:
>>>>> _STA() returns 0x0A instead of 0x0F. Could there be something missing in
>>>>> the ACPI hotplug code that overlooks this and removes the device on
>>>>> resume?
>>>>
>>>> That is possible.  Actually even quite likely, but let's wait for the
>>>> response from Peter.
>>>
>>> Here's a hack that should take the 0xa return value into consideration. It
>>> turned out that this case is even mentioned in the ACPI spec.
>>
>> Tested-by: Peter Wu <lekensteyn@gmail.com>
>>
>> This works, the devices are not lost anymore after resume. dmesg
>> mentions the 04:00.* devices at resume compared to the unpatched kernel:
>>
>> [   42.650721] PM: Finishing wakeup.
>> [   42.650768] acpiphp_glue: hotplug_event: Bus check notify on \_SB_.PCI0.RP03
>> [   42.650772] acpiphp_glue: hotplug_event: re-enumerating slots under \_SB_.PCI0.RP03
>> [   42.650874] iwlwifi 0000:05:00.0: no hotplug settings from platform
>> [   42.650722] Restarting tasks ... done.
>> [   42.650985] video LNXVIDEO:00: Restoring backlight state
>> [   42.650988] video LNXVIDEO:01: Restoring backlight state
>> [   43.124208] ACPI: \_SB_.AC__: ACPI_NOTIFY_BUS_CHECK event: unsupported
>> [   43.128401] jme 0000:04:00.5: irq 50 for MSI/MSI-X
>> [   43.153005] jme 0000:04:00.5 eth0: Link is down
>> [   43.153030] IPv6: ADDRCONF(NETDEV_UP): eth0: link is not ready
>> [   43.154364] iwlwifi 0000:05:00.0: L1 Enabled; Disabling L0S
>> [   43.162307] iwlwifi 0000:05:00.0: Radio type=0x1-0x3-0x1
>> [   43.276220] acpiphp_glue: hotplug_event: Bus check notify on \_SB_.PCI0.RP01
>> [   43.276223] acpiphp_glue: hotplug_event: re-enumerating slots under \_SB_.PCI0.RP01
>> [   43.276257] xhci_hcd 0000:02:00.0: no hotplug settings from platform
>> [   43.276267] acpiphp_glue: hotplug_event: Bus check notify on \_SB_.PCI0.RP02
>> [   43.276268] acpiphp_glue: hotplug_event: re-enumerating slots under \_SB_.PCI0.RP02
>> [   43.276355] sdhci-pci 0000:04:00.0: no hotplug settings from platform
>> [   43.276368] pci 0000:04:00.2: no hotplug settings from platform
>> [   43.276381] jmb38x_ms 0000:04:00.3: no hotplug settings from platform
>> [   43.276393] jme 0000:04:00.5: no hotplug settings from platform
>> [   43.276398] acpiphp_glue: hotplug_event: Bus check notify on \_SB_.PCI0.RP03
>> [   43.276399] acpiphp_glue: hotplug_event: re-enumerating slots under \_SB_.PCI0.RP03
>> [   43.276491] iwlwifi 0000:05:00.0: no hotplug settings from platform
>> [   43.277214] IPv6: ADDRCONF(NETDEV_UP): wlan0: link is not ready
>>
>> Rafael, do you want me to test the other patch as well?
> 
> No, thanks!
> 
> Mika, I'll add a changelog to your patch and queue it up as a fix for 3.14.
> 

Thanks guys for solving this issue !

Rafael, could this be submitted to stable trees (at least 3.12, 3.13) as
well ?