Re: Mwifiex driver on Globalscale Mirabox

[Michael Howard <mike@dewberryfields.co.uk>]

On 15/05/2014 15:06, Avinash Patil wrote:
> Hi James/Anthony,
>
> If an unsupported command is downloaded to FW, it results into command
> response not supported - code 0x2.
> It wouldnt result into command timeout.
> According to our internal discussions, this issue is seen only on
> Globalscale mirabox where SDIO controller is mvsdio.
>
> "On Mirabox the SDIO controller is mvsdio. It polls for interrupts but
> polling itself doesn’t seem to be the problem.
> In the log, I got from another person it seems that there is no
> SDIO_INT bit in controller “intr” register after scan command is sent.
> Other commands are fine, only scan commands fail. I don’t why scan
> (0x06 or 0x107) is special in this case."
>
> Hi Anthony,
>
> Could you please enable dynamic debug on mwifiex, mwifiex_sdio &
> mvsdio driver; this will confirm if this is same issue.
>
> Thanks,
> Avinash.
>
Using kernel 3.15.0-rc5, starting hostapd results in;

May 15 17:11:04 mirabox kernel: mwifiex_sdio mmc0:0001:1: CMD_RESP: cmd 
0x112 error, result=0x2

hostapd runs but there in no AP.

If I can be of any help testing/debugging just say so.

Cheers,
Mike.

--