[PATCH v4 2/2] arm64: enable context tracking

[cov@codeaurora.org (Christopher Covington)]

Hi Larry,

On 05/22/2014 03:27 PM, Larry Bassel wrote:
> Make calls to ct_user_enter when the kernel is exited
> and ct_user_exit when the kernel is entered (in el0_da,
> el0_ia, el0_svc, el0_irq and all of the "error" paths).
> 
> These macros expand to function calls which will only work
> properly if el0_sync and related code has been rearranged
> (in a previous patch of this series).
> 
> The calls to ct_user_exit are made after hw debugging has been
> enabled (enable_dbg_and_irq).
> 
> The call to ct_user_enter is made at the beginning of the
> kernel_exit macro.
> 
> This patch is based on earlier work by Kevin Hilman.
> Save/restore optimizations were also done by Kevin.

> --- a/arch/arm64/kernel/entry.S
> +++ b/arch/arm64/kernel/entry.S
> @@ -30,6 +30,44 @@
>  #include <asm/unistd32.h>
>  
>  /*
> + * Context tracking subsystem.  Used to instrument transitions
> + * between user and kernel mode.
> + */
> +	.macro ct_user_exit, restore = 0
> +#ifdef CONFIG_CONTEXT_TRACKING
> +	bl	context_tracking_user_exit
> +	.if \restore == 1
> +	/*
> +	 * Save/restore needed during syscalls.  Restore syscall arguments from
> +	 * the values already saved on stack during kernel_entry.
> +	 */
> +	ldp	x0, x1, [sp]
> +	ldp	x2, x3, [sp, #S_X2]
> +	ldp	x4, x5, [sp, #S_X4]
> +	ldp	x6, x7, [sp, #S_X6]
> +	.endif
> +#endif
> +	.endm
> +
> +	.macro ct_user_enter, save = 0
> +#ifdef CONFIG_CONTEXT_TRACKING
> +	.if \save == 1
> +	/*
> +	 * Save/restore only needed on syscall fastpath, which uses
> +	 * x0-x2.
> +	 */
> +	push    x2, x3

Why is x3 saved?

> +	push    x0, x1
> +	.endif
> +	bl	context_tracking_user_enter
> +	.if \save == 1
> +	pop     x0, x1
> +	pop     x2, x3
> +	.endif
> +#endif
> +	.endm

Thanks,
Christopher

-- 
Employee of Qualcomm Innovation Center, Inc.
Qualcomm Innovation Center, Inc. is a member of Code Aurora Forum,
hosted by the Linux Foundation.