Re: Problems with pyhBoard-Wega-AM335x

[Frede Florian <florian.frede@ma-info.de>]

Hello Rolf,

after I apply the Patch from Teresa I got the ">".
Yes the last barebox worked. Yesterday I configured the new barebox in 
the same way as the old one and got the ">" the size of my image is only 
93260 bytes so it should work but it do not work. So I will spend no 
more time with the phyWega and wait for the phyCore Kit and start there 
my next try.

Thanks for your helping

Florian

Am 09.07.2014 08:47, schrieb Rolf Evers-Fischer:
> Hello Florian,
>
> On Tue, 8 Jul 2014, Teresa Gamez wrote:
>
>> Hello Florian,
>>
>> I guess you having the default kit WEGA, which does have 256MB RAM. The mainline supported
>> phyCORE Kit does have 512MB. Thats probably why it does not start up.
>>
>> I'll have a look at it.
>>
>> Teresa
>>
> I'm not 100% sure, but I can imagine that the ">" should also appear when
> the SDRAM configuration is not correct. But nevertheless the correct
> SDRAM setting is important. Maybe, you can check the SDRAM setting of your
> previous barebox-2013.11. I assume, the old barebox was running properly,
> wasn't it?
>
>>> Sorry but I have no idea which information I can send you to help me
>>> with my problem...
>>>
> Florian, could you please check the size of your 1st stage bootloader
> (MLO) binary?
> It must not exceed 111616 byte! Otherwise it will not boot.
> You can shrink the size by removing all unnecessary stuff from the
> barebox_mlo configuration.
>
> Best regards,
>   Rolf
>


_______________________________________________
barebox mailing list
barebox@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/barebox