Dell R220 fan speed

Dell R220 fan speed

[Daniele Orlandi]

Hello,

I'm testing XenServer 6.5 beta3 on a couple of Dell R220s equipped with 
a Xeon E3-1220 CPU.

During a cold boot the fans speed starts high, then goes to low, then 
after a while it goes up to high and remains there.

Since the boxes are installed in an office environment it would be 
convenient to have low fan noise so I'm investigating what is happening.

The CPU is mostly idle and apparently runs in P15 state at 800 MHz

[root@xen1 ~]# xenpm get-cpufreq-states
cpu id               : 0
total P-states       : 16
usable P-states      : 16
current frequency    : 800 MHz

ipmitool sensor reads:

Sys Fan1 RPM     | 9480.000   | RPM        | ok    | na        | 720.000 
   | 840.000   | na        | na        | na
Sys Fan2 RPM     | 9480.000   | RPM        | ok    | na        | 720.000 
   | 840.000   | na        | na        | na
Sys Fan3 RPM     | 3120.000   | RPM        | ok    | na        | 720.000 
   | 840.000   | na        | na        | na
Inlet Temp       | 24.000     | degrees C  | ok    | na        | -7.000 
    | 3.000     | 42.000    | 47.000    | na
Temp             | 26.000     | degrees C  | ok    | na        | 3.000 
    | 8.000     | 95.000    | 100.000   | na

The last reading seems to be the CPU or the motherboard and looks pretty 
cool.

Can you suggest what else can I look at and how to make the fans run at 
the proper speed?

Thank you!
Bye,

-- 
   Daniele Orlandi

Re: Dell R220 fan speed

[Ian Campbell]

Hi Daniele, 

On Thu, 2014-10-30 at 14:53 +0100, Daniele Orlandi wrote:
> I'm testing XenServer 6.5 beta3

Questions regarding XenServer are best addressed to the lists and forums
over at www.xenserver.org or to your Support rep.

Ian.

Re: Dell R220 fan speed

[Daniele Orlandi]

On 10/30/2014 03:42 PM, Ian Campbell wrote:
>
> Questions regarding XenServer are best addressed to the lists and forums
> over at www.xenserver.org or to your Support rep.

Oops, sorry, I'm actually subscribed to xs-devel but posted to the wrong 
list.

I'll repost it there.

Thanks,

-- 
   Daniele Orlandi