[PATCH v3 1/2] ARM: hip04: set ARCH_NR_GPIO to 128

[wangzhou.bry@gmail.com (Zhou Wang)]

On 2014?11?28? 17:33, Arnd Bergmann wrote:
> On Friday 28 November 2014 14:29:47 Zhou Wang wrote:
>> Set ARCH_NR_GPIO for Hisilicon Soc Hip04, which has 4 GPIO
>> controllers with 32 GPIOs each.
>>
>> Signed-off-by: Zhou Wang <wangzhou.bry@gmail.com>
>> ---
>>   arch/arm/Kconfig                |    1 +
>>   arch/arm/configs/hisi_defconfig |    3 +++
>>   2 files changed, 4 insertions(+)
>>
>> diff --git a/arch/arm/Kconfig b/arch/arm/Kconfig
>> index 89c4b5c..26aae1e 100644
>> --- a/arch/arm/Kconfig
>> +++ b/arch/arm/Kconfig
>> @@ -1509,6 +1509,7 @@ config ARCH_NR_GPIO
>>          default 352 if ARCH_VT8500
>>          default 288 if ARCH_ROCKCHIP
>>          default 264 if MACH_H4700
>> +       default 128 if ARCH_HIP04
>>          default 0
>>          help
>>            Maximum number of GPIOs in the system.
>>
>
> If I remember correctly, you don't actually need to set this if all gpio
> clients are using the new gpio descriptor interfaces instead of gpio
> numbers. Would that work for you? You'd have to know which devices

Hi Arnd,

If I don't set this, it will use the default ARCH_NR_GPIO(512), then
the range of GPIO number will be 384~511 which is very strange to users,
because Hip04 based machines can only support 128 GPIOs.

Best Regards,
Zhou Wang

> can be connected to the gpio controller for all hip04 based machines,
> but I think this is a short list of boards.
>
> Linus, one question for you: Does the ARCH_NR_GPIO actually work as designed?
> I see that e.g. OMAP4 defines 192 GPIO lines but does not have an ARCH_NR_GPIO
> setting. In an OMAP4-only kernel you would get the default value (512)
> from include/asm-generic/gpio.h, and in a multiplatform kernel you get at
> least 512 if any of the (ARCH_EXYNOS || ARCH_KEYSTONE || SOC_OMAP5 || \
> SOC_DRA7XX || ARCH_S3C24XX || ARCH_S3C64XX || ARCH_S5PV210 || ARCH_SHMOBILE
> || ARCH_TEGRA) are set, so that is still good.
>
> However if one builds a kernel that just enables OMAP4 and HIP04, I suspect
> it can't work on OMAP4 for any gpio line above 128, which seems to be
> a fundamental multiplatform problem.
>
> Do we neet to increase the default to 512 for all ARCH_MULTIPLATFORM
> configurations and just leave ARCH_SHMOBILE, ARCH_TEGRA and MACH_H4700
> here as special cases?
>
> 	Arnd
>