* iMX6 - PMIC SW1AB and SW1C standby voltage setting
@ 2015-04-28 16:03 ansaris
0 siblings, 0 replies; only message in thread
From: ansaris @ 2015-04-28 16:03 UTC (permalink / raw)
To: meta-freescale@yoctoproject.org
Hi,
We are using imx6Q sabresd platform for our development with Linux
3.14.28_1.0.0-GA BSP.
From the below board file we could see the following function
"setup_pmic_voltages".
~/u-boot-imx/board/freescale/mx6sabresd/mx6sabresd.c
We understood that, after detection of PMIC
1. VGEN3 and VGEN5 voltages are increased to 2.8v and 3.0v respectively.
2. The SW1AB and SW1C standby voltages are set to 0.975v.
We would like to know, why the SW1AB and SW1C standby voltages are set
to 0.975? and where this voltage will be used?
Regards,
Ansari
^ permalink raw reply [flat|nested] only message in thread
only message in thread, other threads:[~2015-04-28 16:03 UTC | newest]
Thread overview: (only message) (download: mbox.gz follow: Atom feed
-- links below jump to the message on this page --
2015-04-28 16:03 iMX6 - PMIC SW1AB and SW1C standby voltage setting ansaris
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.