Re: [PATCH] devicetree: bindings: Extend the bma180 bindings with bma250 info

[Rob Herring <robh@kernel.org>]

On 09/12/2015 05:52 AM, Hans de Goede wrote:
> The bma180 / bma250 accelerometers share a driver (at least under Linux),
> so it makes sense to also have their bindings info in a single .txt.
> 
> This commit extends the bma180 bindings with bma250 bindings, specifically
> it specifies how the 2 seperate interrupts the bma250 has must be listed
> in devicetree. The existing bma180 driver is already fully compatible
> with the specified bindings.
> 
> Signed-off-by: Hans de Goede <hdegoede@redhat.com>

Applied, thanks.

Rob

> ---
>  Documentation/devicetree/bindings/iio/accel/bma180.txt | 8 ++++++--
>  1 file changed, 6 insertions(+), 2 deletions(-)
> 
> diff --git a/Documentation/devicetree/bindings/iio/accel/bma180.txt b/Documentation/devicetree/bindings/iio/accel/bma180.txt
> index c593357..4a3679d 100644
> --- a/Documentation/devicetree/bindings/iio/accel/bma180.txt
> +++ b/Documentation/devicetree/bindings/iio/accel/bma180.txt
> @@ -1,10 +1,11 @@
> -* Bosch BMA180 triaxial acceleration sensor
> +* Bosch BMA180 / BMA250 triaxial acceleration sensor
>  
>  http://omapworld.com/BMA180_111_1002839.pdf
> +http://ae-bst.resource.bosch.com/media/products/dokumente/bma250/bst-bma250-ds002-05.pdf
>  
>  Required properties:
>  
> -  - compatible : should be "bosch,bma180"
> +  - compatible : should be "bosch,bma180" or "bosch,bma250"
>    - reg : the I2C address of the sensor
>  
>  Optional properties:
> @@ -13,6 +14,9 @@ Optional properties:
>  
>    - interrupts : interrupt mapping for GPIO IRQ, it should by configured with
>  		flags IRQ_TYPE_LEVEL_HIGH | IRQ_TYPE_EDGE_RISING
> +		For the bma250 the first interrupt listed must be the one
> +		connected to the INT1 pin, the second (optional) interrupt
> +		listed must be the one connected to the INT2 pin.
>  
>  Example:
>  
>