From: Damien Horsley <Damien.Horsley-1AXoQHu6uovQT0dZR+AlfA@public.gmane.org>
To: Mark Brown <broonie-DgEjT+Ai2ygdnm+yROfE0A@public.gmane.org>
Cc: alsa-devel-K7yf7f+aM1XWsZ/bQMPhNw@public.gmane.org,
Rob Herring <robh+dt-DgEjT+Ai2ygdnm+yROfE0A@public.gmane.org>,
Pawel Moll <pawel.moll-5wv7dgnIgG8@public.gmane.org>,
Mark Rutland <mark.rutland-5wv7dgnIgG8@public.gmane.org>,
Ian Campbell
<ijc+devicetree-KcIKpvwj1kUDXYZnReoRVg@public.gmane.org>,
Kumar Gala <galak-sgV2jX0FEOL9JmXXK+q4OQ@public.gmane.org>,
Liam Girdwood <lgirdwood-Re5JQEeQqe8AvxtiuMwx3w@public.gmane.org>,
Jaroslav Kysela <perex-/Fr2/VpizcU@public.gmane.org>,
Takashi Iwai <tiwai-IBi9RG/b67k@public.gmane.org>,
devicetree-u79uwXL29TY76Z2rM5mHXA@public.gmane.org,
linux-kernel-u79uwXL29TY76Z2rM5mHXA@public.gmane.org,
James Hartley
<james.hartley-1AXoQHu6uovQT0dZR+AlfA@public.gmane.org>
Subject: Re: [RFC V2 1/2] ASoC: img: Add binding document for Pistachio audio card
Date: Wed, 27 Jan 2016 17:13:09 +0000 [thread overview]
Message-ID: <56A8FAA5.1000907@imgtec.com> (raw)
In-Reply-To: <20160127160057.GA25316-GFdadSzt00ze9xe1eoZjHA@public.gmane.org>
On 27/01/16 16:00, Mark Brown wrote:
> On Wed, Jan 27, 2016 at 03:18:20PM +0000, Damien Horsley wrote:
>> On 27/01/16 14:57, Mark Brown wrote:
>>> On Tue, Jan 26, 2016 at 02:34:26PM +0000, Damien Horsley wrote:
>
>>>> + - clock-names : Includes the following entries:
>>>> + "audio_pll" The audio PLL
>>>> + "i2s_mclk" The i2s reference clock
>>>> + Also connected to i2s_out_0_mclk output
>>>> + "dac_mclk" Dac reference clock. Connected to i2s_dac_clk output
>
>>> Why are these (especially the dac_mclk and i2s_mclk) properties of the
>>> card and not of the drivers for the respective devices?
>
>> Due to the shared nature of these clocks. Individual components cannot
>> be responsible for controlling these as this could break configurations
>> for other components that are sharing the clocks. Only the card driver
>> has visibility of all of the components and their requirements.
>
> You're talking about the code that decides what rates to set the clock
> at, not where the properties are placed in the DT.
>
>> i2s_mclk and dac_mclk can be used by both the i2s in and i2s out paths
>> on some boards
>
> Multiple devices can reference the same clock.
>
audio_pll is referenced exclusively by the card device
i2s_mclk and dac_mclk can also be referenced by other devices. The i2s
out controller references i2s_mclk, and codec devices can reference
i2s_mclk/dac_mclk dependent on their system clock requirements
without a reference to i2s_mclk and dac_mclk in the card driver, it
would not be possible to control the divisors and gates for these clocks
in the following cases:
Simplistic codecs that do not have drivers
Codec drivers that do not call clk_set_rate and clk_enable/clk_disable
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo-u79uwXL29TY76Z2rM5mHXA@public.gmane.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
WARNING: multiple messages have this Message-ID (diff)
From: Damien Horsley <Damien.Horsley@imgtec.com>
To: Mark Brown <broonie@kernel.org>
Cc: <alsa-devel@alsa-project.org>, Rob Herring <robh+dt@kernel.org>,
Pawel Moll <pawel.moll@arm.com>,
Mark Rutland <mark.rutland@arm.com>,
Ian Campbell <ijc+devicetree@hellion.org.uk>,
Kumar Gala <galak@codeaurora.org>,
Liam Girdwood <lgirdwood@gmail.com>,
Jaroslav Kysela <perex@perex.cz>, Takashi Iwai <tiwai@suse.com>,
<devicetree@vger.kernel.org>, <linux-kernel@vger.kernel.org>,
James Hartley <james.hartley@imgtec.com>
Subject: Re: [RFC V2 1/2] ASoC: img: Add binding document for Pistachio audio card
Date: Wed, 27 Jan 2016 17:13:09 +0000 [thread overview]
Message-ID: <56A8FAA5.1000907@imgtec.com> (raw)
In-Reply-To: <20160127160057.GA25316@sirena.org.uk>
On 27/01/16 16:00, Mark Brown wrote:
> On Wed, Jan 27, 2016 at 03:18:20PM +0000, Damien Horsley wrote:
>> On 27/01/16 14:57, Mark Brown wrote:
>>> On Tue, Jan 26, 2016 at 02:34:26PM +0000, Damien Horsley wrote:
>
>>>> + - clock-names : Includes the following entries:
>>>> + "audio_pll" The audio PLL
>>>> + "i2s_mclk" The i2s reference clock
>>>> + Also connected to i2s_out_0_mclk output
>>>> + "dac_mclk" Dac reference clock. Connected to i2s_dac_clk output
>
>>> Why are these (especially the dac_mclk and i2s_mclk) properties of the
>>> card and not of the drivers for the respective devices?
>
>> Due to the shared nature of these clocks. Individual components cannot
>> be responsible for controlling these as this could break configurations
>> for other components that are sharing the clocks. Only the card driver
>> has visibility of all of the components and their requirements.
>
> You're talking about the code that decides what rates to set the clock
> at, not where the properties are placed in the DT.
>
>> i2s_mclk and dac_mclk can be used by both the i2s in and i2s out paths
>> on some boards
>
> Multiple devices can reference the same clock.
>
audio_pll is referenced exclusively by the card device
i2s_mclk and dac_mclk can also be referenced by other devices. The i2s
out controller references i2s_mclk, and codec devices can reference
i2s_mclk/dac_mclk dependent on their system clock requirements
without a reference to i2s_mclk and dac_mclk in the card driver, it
would not be possible to control the divisors and gates for these clocks
in the following cases:
Simplistic codecs that do not have drivers
Codec drivers that do not call clk_set_rate and clk_enable/clk_disable
next prev parent reply other threads:[~2016-01-27 17:13 UTC|newest]
Thread overview: 15+ messages / expand[flat|nested] mbox.gz Atom feed top
2016-01-26 14:34 [RFC V2 0/2] ASoC: img: Add Pistachio card support Damien Horsley
2016-01-26 14:34 ` [RFC V2 1/2] ASoC: img: Add binding document for Pistachio audio card Damien Horsley
2016-01-27 14:57 ` Mark Brown
2016-01-27 15:18 ` Damien Horsley
2016-01-27 15:18 ` Damien Horsley
2016-01-27 16:00 ` Mark Brown
2016-01-27 16:00 ` Mark Brown
[not found] ` <20160127160057.GA25316-GFdadSzt00ze9xe1eoZjHA@public.gmane.org>
2016-01-27 17:13 ` Damien Horsley [this message]
2016-01-27 17:13 ` Damien Horsley
2016-01-27 20:14 ` Mark Brown
2016-01-27 20:14 ` Mark Brown
2016-01-28 14:17 ` Damien Horsley
2016-01-28 14:17 ` Damien Horsley
2016-01-28 23:25 ` Mark Brown
2016-01-26 14:34 ` [RFC V2 2/2] ASoC: img: Add driver " Damien Horsley
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=56A8FAA5.1000907@imgtec.com \
--to=damien.horsley-1axoqhu6uovqt0dzr+alfa@public.gmane.org \
--cc=alsa-devel-K7yf7f+aM1XWsZ/bQMPhNw@public.gmane.org \
--cc=broonie-DgEjT+Ai2ygdnm+yROfE0A@public.gmane.org \
--cc=devicetree-u79uwXL29TY76Z2rM5mHXA@public.gmane.org \
--cc=galak-sgV2jX0FEOL9JmXXK+q4OQ@public.gmane.org \
--cc=ijc+devicetree-KcIKpvwj1kUDXYZnReoRVg@public.gmane.org \
--cc=james.hartley-1AXoQHu6uovQT0dZR+AlfA@public.gmane.org \
--cc=lgirdwood-Re5JQEeQqe8AvxtiuMwx3w@public.gmane.org \
--cc=linux-kernel-u79uwXL29TY76Z2rM5mHXA@public.gmane.org \
--cc=mark.rutland-5wv7dgnIgG8@public.gmane.org \
--cc=pawel.moll-5wv7dgnIgG8@public.gmane.org \
--cc=perex-/Fr2/VpizcU@public.gmane.org \
--cc=robh+dt-DgEjT+Ai2ygdnm+yROfE0A@public.gmane.org \
--cc=tiwai-IBi9RG/b67k@public.gmane.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.