[PATCH v3 2/2] ARM: dts: utilite-pro: add mmc card slot support

[grinberg@compulab.co.il (Igor Grinberg)]

Hi Christopher,

On 06/13/2016 02:24 AM, christopher.spinrath at rwth-aachen.de wrote:
> From: Christopher Spinrath <christopher.spinrath@rwth-aachen.de>
> 
> The Utilite Pro has a mmc card slot connected to the usdhc3
> controller. There is no card detection until hardware revision 1.3.
> 
> Add support for it and signal the controller with the broken-cd
> property that polling has to be used to detect a card.
> 
> Signed-off-by: Christopher Spinrath <christopher.spinrath@rwth-aachen.de>
> Reviewed-by: Fabio Estevam <fabio.estevam@nxp.com>
> ---
> 
> Notes:
>     Changes since v2:
>      - add Fabio's Reviewed-By
>     
>     Changes since v1:
>      - enhance commit message to explain to the broken-cd property
> 
>  arch/arm/boot/dts/imx6q-utilite-pro.dts | 44 +++++++++++++++++++++++++++++++++
>  1 file changed, 44 insertions(+)
> 
> diff --git a/arch/arm/boot/dts/imx6q-utilite-pro.dts b/arch/arm/boot/dts/imx6q-utilite-pro.dts
> index 7219745..6199063 100644
> --- a/arch/arm/boot/dts/imx6q-utilite-pro.dts
> +++ b/arch/arm/boot/dts/imx6q-utilite-pro.dts

[...]

> @@ -151,3 +184,14 @@
>  	uart-has-rtscts;
>  	status = "okay";
>  };
> +
> +&usdhc3 {
> +	pinctrl-names = "default", "state_100mhz", "state_200mhz";
> +	pinctrl-0 = <&pinctrl_usdhc3>;
> +	pinctrl-1 = <&pinctrl_usdhc3_100mhz>;
> +	pinctrl-2 = <&pinctrl_usdhc3_200mhz>;
> +	no-1-8-v;
> +	broken-cd;

A wast majority of boards produced are of revision >=1.3.
Can we please have the default as revision 1.3 with cd?
And let the patch you have submitted to U-Boot do the job
for older revisions?

> +	keep-power-in-suspend;
> +	status = "okay";
> +};
> 

-- 
Regards,
Igor.