if i hope to build relay network via batman-adv , whether i will obtain Networkcoding part via config menuconfig and compile?

if i hope to build relay network via batman-adv , whether i will obtain Networkcoding part via config menuconfig and compile?

[johnzeng]

Hello Dear Sir :

if i hope to build relay network via batman-adv , whether i will obtain
Networkcoding part via config menuconfig and compile.

whether i need config other except part A ?

Part A

	 batctl nc 0
	 echo 0 > /sys/class/net/bat0/mesh/network_coding
	 ip link set dev wlan0 promisc on
	 ip link set dev wlan0 mtu 1546


           Thanks 

Re: if i hope to build relay network via batman-adv , whether i will obtain Networkcoding part via config menuconfig and compile?

[johnzeng]

Hello Dear SIr :

When i compile the part , whether i need make
CONFIG_BATMAN_ADV_BATMAN_V=y at batman-adv-2016.2


Thanks
> Hello Dear Sir :
>
> if i hope to build relay network via batman-adv , whether i will obtain
> Networkcoding part via config menuconfig and compile.
>
> whether i need config other except part A ?
>
> Part A
>
> 	 batctl nc 0
> 	 echo 0 > /sys/class/net/bat0/mesh/network_coding
> 	 ip link set dev wlan0 promisc on
> 	 ip link set dev wlan0 mtu 1546
>
>
>            Thanks 
>
>
>

Re: if i hope to build relay network via batman-adv , whether i will obtain Networkcoding part via config menuconfig and compile?

[johnzeng]

Hello Dear Sven:

there are /a clerical/ //error// about batctl nc and i compiled the part .

run these command in according to advisement for relay mode

	      batctl nc 1
	      echo 1 > /sys/class/net/bat0/mesh/network_coding
	      ip link set dev wlan0 promisc on
	      ip link set dev wlan0 mtu 1546



if i send a packet from host A to hostC via hostB, whether hostB will
open relay mode at layer2 .


Best Regards

TIger