* [Xenomai-help] xenomai installation
@ 2008-04-25 18:37 George Pitich
2008-04-25 19:52 ` Gilles Chanteperdrix
0 siblings, 1 reply; 5+ messages in thread
From: George Pitich @ 2008-04-25 18:37 UTC (permalink / raw)
To: xenomai
I'm pretty much sure this was answered before. If this
is the case could you please refer me to the post?
I'm getting a bit frustrated in my attempts to install
xenomai. I'm following the readme.install from
xenomai-2.4.3 but to no avail. When I execute make
menuconfig after patching the kernel with
prepare-kernel.sh, Real-time sub-system presents me
with:
-- NOTE: Xenomai conflicts with PC speaker support.
--- (menu Device Drivers/Input device
support/Miscellaneous devices)
--- NOTE: Xenomai needs either X86_LOCAL_APIC enabled
or HPET_TIMER disabled. │ │
--- (menu Processor type and features)).
None of this options is selectable nor configurable.
By looking into .config, I can see only one xeno
option CONFIG_XENO_GENERIC_STACKPOOL=y. After
compiling the kernel and booting it, xenomai build
looks incomplete. I can't find xenomai LKMs and
therefore can't run testsuite.
I hope it is not because of AMD Athlon cpu on the box.
Many Thanks.
____________________________________________________________________________________
Be a better friend, newshound, and
know-it-all with Yahoo! Mobile. Try it now. http://mobile.yahoo.com/;_ylt=Ahu06i62sR8HDtDypao8Wcj9tAcJ
^ permalink raw reply [flat|nested] 5+ messages in thread
* Re: [Xenomai-help] xenomai installation
2008-04-25 18:37 [Xenomai-help] xenomai installation George Pitich
@ 2008-04-25 19:52 ` Gilles Chanteperdrix
2008-04-26 19:58 ` George Pitich
0 siblings, 1 reply; 5+ messages in thread
From: Gilles Chanteperdrix @ 2008-04-25 19:52 UTC (permalink / raw)
To: George Pitich; +Cc: xenomai
George Pitich wrote:
> I'm pretty much sure this was answered before. If this
> is the case could you please refer me to the post?
>
> I'm getting a bit frustrated in my attempts to install
> xenomai. I'm following the readme.install from
> xenomai-2.4.3 but to no avail. When I execute make
> menuconfig after patching the kernel with
> prepare-kernel.sh, Real-time sub-system presents me
> with:
Please do the following in Linux kernel configuration:
>
> -- NOTE: Xenomai conflicts with PC speaker support.
> --- (menu Device Drivers/Input device
> support/Miscellaneous devices)
disable PC speaker support (you will find it in the Device Drivers/Input
device support/Miscellaneous devices menu).
> --- NOTE: Xenomai needs either X86_LOCAL_APIC enabled
> or HPET_TIMER disabled. │ │
> --- (menu Processor type and features)).
Enable Local APIC option (if your box has a local APIC, but anything
recent probably has an APIC), or disable HPET timer option (you will find
these options in the Processor type and features menu).
--
Gilles.
^ permalink raw reply [flat|nested] 5+ messages in thread
* Re: [Xenomai-help] xenomai installation
2008-04-25 19:52 ` Gilles Chanteperdrix
@ 2008-04-26 19:58 ` George Pitich
2008-04-26 21:45 ` George Pitich
2008-04-27 12:04 ` Gilles Chanteperdrix
0 siblings, 2 replies; 5+ messages in thread
From: George Pitich @ 2008-04-26 19:58 UTC (permalink / raw)
To: xenomai
> Please do the following in Linux kernel
> configuration:
>
> >
> > -- NOTE: Xenomai conflicts with PC speaker
> support.
> > --- (menu Device Drivers/Input device
> > support/Miscellaneous devices)
>
> disable PC speaker support (you will find it in the
> Device Drivers/Input
> device support/Miscellaneous devices menu).
>
> > --- NOTE: Xenomai needs either X86_LOCAL_APIC
> enabled
> > or HPET_TIMER disabled. │
> │
> > --- (menu Processor type and features)).
>
> Enable Local APIC option (if your box has a local
> APIC, but anything
> recent probably has an APIC), or disable HPET timer
> option (you will find
> these options in the Processor type and features
> menu).
>
Thanks for the help, now I made a progress and
installed xenomai. I had to compile it with
--enable-x86-tsc=no flag since my testsuite won't run
without a TSC support and I don't know where to
configure this flag during the initial kernel config
process (make menuconfig)? Is it a processor family
specific?
Interestingly enough after a boot, klatency test runs,
but if i stop it (ctrl-c) and run it again it
segfaults:
/usr/xenomai/bin/xeno-load: line 180: 22756
Segmentation fault $suflag $* $cmdargs
irqbench also won't run:
irqloop: error starting test: Inappropriate ioctl for
device
Regards,
g.
____________________________________________________________________________________
Be a better friend, newshound, and
know-it-all with Yahoo! Mobile. Try it now. http://mobile.yahoo.com/;_ylt=Ahu06i62sR8HDtDypao8Wcj9tAcJ
^ permalink raw reply [flat|nested] 5+ messages in thread
* Re: [Xenomai-help] xenomai installation
2008-04-26 19:58 ` George Pitich
@ 2008-04-26 21:45 ` George Pitich
2008-04-27 12:04 ` Gilles Chanteperdrix
1 sibling, 0 replies; 5+ messages in thread
From: George Pitich @ 2008-04-26 21:45 UTC (permalink / raw)
To: xenomai
> Interestingly enough after a boot, klatency test
> runs,
> but if i stop it (ctrl-c) and run it again it
> segfaults:
>
> /usr/xenomai/bin/xeno-load: line 180: 22756
> Segmentation fault $suflag $* $cmdargs
just figured out that it might be because of (ARCH)
uname -i gives unknown?
____________________________________________________________________________________
Be a better friend, newshound, and
know-it-all with Yahoo! Mobile. Try it now. http://mobile.yahoo.com/;_ylt=Ahu06i62sR8HDtDypao8Wcj9tAcJ
^ permalink raw reply [flat|nested] 5+ messages in thread
* Re: [Xenomai-help] xenomai installation
2008-04-26 19:58 ` George Pitich
2008-04-26 21:45 ` George Pitich
@ 2008-04-27 12:04 ` Gilles Chanteperdrix
1 sibling, 0 replies; 5+ messages in thread
From: Gilles Chanteperdrix @ 2008-04-27 12:04 UTC (permalink / raw)
To: George Pitich; +Cc: xenomai
George Pitich wrote:
>
> > Please do the following in Linux kernel
> > configuration:
> >
> > >
> > > -- NOTE: Xenomai conflicts with PC speaker
> > support.
> > > --- (menu Device Drivers/Input device
> > > support/Miscellaneous devices)
> >
> > disable PC speaker support (you will find it in the
> > Device Drivers/Input
> > device support/Miscellaneous devices menu).
> >
> > > --- NOTE: Xenomai needs either X86_LOCAL_APIC
> > enabled
> > > or HPET_TIMER disabled. │
> > │
> > > --- (menu Processor type and features)).
> >
> > Enable Local APIC option (if your box has a local
> > APIC, but anything
> > recent probably has an APIC), or disable HPET timer
> > option (you will find
> > these options in the Processor type and features
> > menu).
> >
>
> Thanks for the help, now I made a progress and
> installed xenomai. I had to compile it with
> --enable-x86-tsc=no flag since my testsuite won't run
> without a TSC support and I don't know where to
> configure this flag during the initial kernel config
> process (make menuconfig)? Is it a processor family
> specific?
It depends on the processor you select.
>
> Interestingly enough after a boot, klatency test runs,
> but if i stop it (ctrl-c) and run it again it
> segfaults:
>
> /usr/xenomai/bin/xeno-load: line 180: 22756
> Segmentation fault $suflag $* $cmdargs
Please select the klatency kernel support as a module, not built-in
kernel. Will fix.
--
Gilles.
^ permalink raw reply [flat|nested] 5+ messages in thread
end of thread, other threads:[~2008-04-27 12:04 UTC | newest]
Thread overview: 5+ messages (download: mbox.gz follow: Atom feed
-- links below jump to the message on this page --
2008-04-25 18:37 [Xenomai-help] xenomai installation George Pitich
2008-04-25 19:52 ` Gilles Chanteperdrix
2008-04-26 19:58 ` George Pitich
2008-04-26 21:45 ` George Pitich
2008-04-27 12:04 ` Gilles Chanteperdrix
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.