Re: [PATCH v3] arm64: dts: rockchip: enable SD UHS-I on Firefly-RK3399

["Heiko Stübner" <heiko@sntech.de>]

Hi,

Am Freitag, 6. November 2026, 07:18:35 Mitteleuropäische Normalzeit schrieb Yaozhong Li:
[...]
> - Describe the slot's own supply, vcc_sd, and use it as the sdmmc
>   vmmc-supply (Heiko). It is fed from vcc3v3_sys, and GPIO4_D6 controls
>   the slot power switch: holding the pin low leaves the card unpowered.
>   This is the same arrangement as vcc3v0_sd on the ROC-PC. The existing,
>   unreferenced lcd_panel_reset pinctrl entry also names GPIO4_D6; the
>   vendor tree uses the pin only for vcc_sd.

I you're reading the schematics, this is wrong.

In the schematics file Shawn linked to earlier (and also the one I have),
GPIO4_D6 is connected to the reset-pin of an AT18.

While the vcc3v0_sd is an always on regulator coming from vcc3v3_sys.
As stated in v2, see page 20 of your schematics.

So you essentially just set vmmc-supply to vcc3v3_sys. As I said that is
merely descriptive.


Heiko

> - Link to v2: https://lore.kernel.org/all/20261105102556.1365-1-yaozhonguwl@gmail.com/
> 
> Changes in v2:
> - Point the sdio0 vmmc-supply at vcc3v3_sys, the WiFi module's VBAT input,
>   instead of dropping it (Heiko)
> - Rewrite the commit message (Heiko)
> - Link to v1: https://lore.kernel.org/all/20260922055011.14972-1-yaozhonguwl@gmail.com/
> 
> On the boot-time issue described in v2: with the vmmc-supply in place
> the sdmmc controller now probes after the GRF io-domain here, and a card
> present at boot came up in SDR104 in 5 of 5 warm boots, against 0 of 8
> before. That is a change in probe order rather than a fix for the
> ordering problem itself.
> 
>  .../boot/dts/rockchip/rk3399-firefly.dts      | 24 ++++++++++++++++++-
>  1 file changed, 23 insertions(+), 1 deletion(-)
> 
> diff --git a/arch/arm64/boot/dts/rockchip/rk3399-firefly.dts b/arch/arm64/boot/dts/rockchip/rk3399-firefly.dts
> index 0568dfa..03858a4 100644
> --- a/arch/arm64/boot/dts/rockchip/rk3399-firefly.dts
> +++ b/arch/arm64/boot/dts/rockchip/rk3399-firefly.dts
> @@ -233,6 +233,19 @@ vcc5v0_typec: regulator-vcc5v0-typec {
>  		vin-supply = <&vcc_sys>;
>  	};
>  
> +	vcc_sd: regulator-vcc-sd {
> +		compatible = "regulator-fixed";
> +		enable-active-high;
> +		gpio = <&gpio4 RK_PD6 GPIO_ACTIVE_HIGH>;
> +		pinctrl-names = "default";
> +		pinctrl-0 = <&vcc_sd_en>;
> +		regulator-name = "vcc_sd";
> +		regulator-boot-on;
> +		regulator-min-microvolt = <3300000>;
> +		regulator-max-microvolt = <3300000>;
> +		vin-supply = <&vcc3v3_sys>;
> +	};
> +
>  	vcc_sys: regulator-vcc-sys {
>  		compatible = "regulator-fixed";
>  		regulator-name = "vcc_sys";
> @@ -731,6 +744,12 @@ wifi_enable_h: wifi-enable-h {
>  		};
>  	};
>  
> +	sdmmc {
> +		vcc_sd_en: vcc-sd-en {
> +			rockchip,pins = <4 RK_PD6 RK_FUNC_GPIO &pcfg_pull_none>;
> +		};
> +	};
> +
>  	usb-typec {
>  		vcc5v0_typec_en: vcc5v0_typec_en {
>  			rockchip,pins = <1 RK_PA3 RK_FUNC_GPIO &pcfg_pull_up>;
> @@ -777,7 +796,7 @@ &sdio0 {
>  
>  	/* Power supply */
>  	vqmmc-supply = <&vcc1v8_s3>;	/* IO line */
> -	vmmc-supply = <&vcc_sdio>;	/* card's power */
> +	vmmc-supply = <&vcc3v3_sys>;	/* card's power */
>  
>  	#address-cells = <1>;
>  	#size-cells = <0>;
> @@ -804,6 +823,9 @@ &sdmmc {
>  	max-frequency = <150000000>;
>  	pinctrl-names = "default";
>  	pinctrl-0 = <&sdmmc_clk &sdmmc_cmd &sdmmc_bus4>;
> +	sd-uhs-sdr104;
> +	vmmc-supply = <&vcc_sd>;
> +	vqmmc-supply = <&vcc_sdio>;
>  	status = "okay";
>  };
>  
> 
> base-commit: 940de590b839f71d6dc846160534bf202401b8b7
>