Re: 43p-140 install issues

[Mike Martin <sydneymartin@gmail.com>]

On Mon, 3 Jan 2005 08:05:35 +0100, Sven Luther <sven.luther@wanadoo.fr> wrote:

[snip]
> There may be some problems with 2.6 kernels and pci irqs on prep. I will
> investigate this shortly.

There is definitely something strange happening. The image I used to
do the (nearly) complete install will no longer configure the network.
Very inconsistent. I will try it (same image) again later today and
see if it "just works" next time - like it did last time.

[snip]
> 
> Yep. Until partman-prep is ready, you should simply try to add the prep flag
> to the a small partition. I think the normal scheme is to create /dev/sdb1 as
> a small (8MB ?) prep partition, /dev/sdb2 as swap, and /dev/sdb3 as /. If
> partman is not able to do it, jump to console 2, and launch parted directly,
> and do a set 1 prep on.

Can't jump to console 2 - I can only comunicate through the serial
console. However I'll give this a shot through the "execute shell"
menu item. "set 1 prep on"? Haven't seen that documented anywhere,
what does it do?

> 
> Then i suppose that copying the kernel is just a matter of :
> 
>   dd if=/boot/vmlinuz-2.6.8-powerpc of=/dev/sdb1
> 
> but you have to have a small prep partition as /dev/sdb1, or the above will
> erase whatever you have on /dev/sdb1.
> 

I' have the partition ready ...

Unfortunately, until the network comes back up, I can't get far enough
in the install to access the SCSI drives (is there another way? Load
the modules by hand? Which ones?). Without this, I can't get at the
image I need to boot in order to get it onto the right partition. I
also can't get it to another machine to net boot it.

> > I tried booting up with the installer, going to a shell after the scsi
> > was active and the installed system was mounted. I used sfdisk from
> > /target/sbin to create a 10 Meg type 41 partition on the first HD
> > (/dev/sdb0 eventually). I used dd to copy /target/boot/vmlinux to this
> > partition. But it still won't boot.
> 
> Ah, no sure what is wrong. I don't think /dev/sdb0 exists. Not sure really.
> 

Actually /dev/sdbX doesn't exist at all during the install from what I
have seen. The drives are refered to as
/dev/scsi/host0/etc/.../etc/part1. I have two drives, one is 9 Gig
with scsi id (0,4,0) (/dev/sda) . This is blank except for a 10 Meg
boot partition; type 41. The second drive is 20 Gig with scsi id
(0,5,0)(/dev/sdb) which is where the install is.

I copied (with dd) the file (the wrong file I suspect) to
/dev/scsi/...../part1 which should correspond to the first partiton on
the 9 Gig drive.

I see how much more time I can buy with this machine. It may need to
go back into storage this week if I can't make it run. Not fun.

Thanks for everyone's help. 
MikeMartin