From: bugtrack@alsa-project.org
To: alsa-devel@alsa-project.org
Subject: [ALSA - driver 0000724]: No apparent support for Creative Sounblaster 24 bit.
Date: Sat, 28 May 2005 20:02:53 +0200 [thread overview]
Message-ID: <87d087b58a124c44295addfe18fa19c7@bugtrack.alsa-project.org> (raw)
The following issue has been ASSIGNED.
======================================================================
<https://bugtrack.alsa-project.org/alsa-bug/view.php?id=724>
======================================================================
Reported By: sjberryman
Assigned To: jcdutton
======================================================================
Project: ALSA - driver
Issue ID: 724
Category: OTHERS
Reproducibility: always
Severity: major
Priority: normal
Status: assigned
Distribution: Fedora Core1, Core2 and Suse 9.2
Kernel Version: 2.6.9 2.4.28 2.6.8
======================================================================
Date Submitted: 12-13-2004 09:21 CET
Last Modified: 05-28-2005 20:02 CEST
======================================================================
Summary: No apparent support for Creative Sounblaster 24 bit.
Description:
No apparent support for Creative Sounblaster 24 bit.
Fedora does not find any sound device.
Susi finds a device but can't activate it.
======================================================================
----------------------------------------------------------------------
pzad - 12-13-04 10:07
----------------------------------------------------------------------
Support for SB Live 24 bit was added to ALSA only recently and is available
only in ALSA CVS. Only analog outputs work for now.
----------------------------------------------------------------------
sjberryman - 01-19-05 09:08
----------------------------------------------------------------------
I have tested the last three driver releases 1.0.8rc1 1.0.8rc2 1.0.8 from
the alsa project.
The SB live 24 bit card was detected on boot but did not work when
detection attempted by the Fedora core2 system-config-soundcard.
The output was
The following audio device was detected
Vendor: Creative Labs
Model: SB Audigy LS
Module: snd-ca0106
Tested with 2.6.9-1.11_FC2smp and 2.6.9-1.6_FC2smp
----------------------------------------------------------------------
tiwai - 01-19-05 14:27
----------------------------------------------------------------------
If you get an entry in /proc/asound/cards after loading snd-ca0106, it
means that ALSA is basically working. The other is the problem of Fedora.
----------------------------------------------------------------------
nadavkav - 01-22-05 22:15
----------------------------------------------------------------------
I'm using fc3 (devel), i got the 1.0.8 versions from cvs , compiled,
installed , loaded the module (alsaconf - configured it) and i have it
working.
actually... partially.
i looked into the sources (ca0106.c) and saw that recording/midi/other
features are not implemented yet. it is only playbacking.
i'd like to help make it work so i emailed the developer (james) that i
wish to help.
:-)
----------------------------------------------------------------------
fmoraes - 01-22-05 23:20
----------------------------------------------------------------------
If you want to add MIDI support, you can try adapting the code in the
emu10k1x.c driver, which should be very similar to the ca0106 driver.
----------------------------------------------------------------------
Kane32 - 01-25-05 22:39
----------------------------------------------------------------------
Aparently only 48.000Hz output works properly with this card (with 44.000Hz
the sound is stuttering), is this going to be fixed soon?
It would also be nice to use all speakers from my 7.1-soundsystem, will
this be implemented?
----------------------------------------------------------------------
nadavkav - 01-26-05 13:18
----------------------------------------------------------------------
i was emailing with james (who wrote the driver); and he wrote to me that
the mic/line-in and midi is not going to be implemented soon because the
info he got from creative is not enough to figure it all out.
----------------------------------------------------------------------
sHINOBI - 02-08-05 23:32
----------------------------------------------------------------------
Hello, I have K8N SLI Platinum motherboard with integrated SB Live 24 bit.
I tried the drivers 1.0.8, but with no luck. There is a following log in
messages:
kernel: AC'97 0 does not respond - RESET
kernel: AC'97 0 access is not valid [0x0], removing mixer.
kernel: CA0106: probe of 0000:01:0d.0 failed with error -5
Does anyone has an idea what should be wrong or how can I debug it
further?
I use Fedora Core 3 and the latest devel kernel. The soundcard is detected
(the same way as sjberryman) but /proc/asound/cards is empty.
----------------------------------------------------------------------
pzad - 02-09-05 07:25
----------------------------------------------------------------------
This card probably doesn't have AC97 too.
Search ca0106 driver for line
if ((chip->serial != 0x10061102) && (chip->serial != 0x10071102) ) { /*
The SB0410 and SB0413 do not have an ac97 chip. */
and add chip->serial of your card there too.
----------------------------------------------------------------------
sHINOBI - 02-09-05 08:57
----------------------------------------------------------------------
Errm, to be honest I'm not sure with the chip->serial number. I guess it
should be listed with lspci -nvv command. Relevant part is:
01:0d.0 Class 0401: 1102:0007
Subsystem: 1462:1009
Control: I/O+ Mem- BusMaster+ SpecCycle- MemWINV- VGASnoop-
ParErr- Stepping- SERR- FastB2B-
Status: Cap+ 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort- >SERR- <PERR-
Latency: 32 (500ns min, 5000ns max)
Interrupt: pin A routed to IRQ 11
Region 0: I/O ports at de00 [size=32]
Capabilities: [dc] Power Management version 2
Flags: PMEClk- DSI+ D1+ D2+ AuxCurrent=0mA
PME(D0-,D1-,D2-,D3hot-,D3cold-)
Status: D0 PME-Enable- DSel=0 DScale=0 PME-
BTW should be the James notified about this card?
----------------------------------------------------------------------
sjberryman - 05-28-05 16:06
----------------------------------------------------------------------
I have once again tested the latest alsa driver release 1.0.9 with FC3
kernel 2.6.11-1.27_FC3 on a Dell
Tried to set it up according to the instructions in the soundcards link.
When I run the config-system-sound utility I get
"
amixer: Unable to find simple control 'Master',0
amixer: Unable to find simple control 'PCM',0
Playing WAVE '/usr/share/system-config-soundcard/sound-sample.wav' :
Signed 16 bit Little Endian, Rate 44100 Hz, Stereo
Warning: rate is not accurate (requested = 44100Hz, got = 48000Hz)
please, try the plug plugin (-Dplug:hw:0,0)
"
When I try to play an mp3 file using mpg321 I get
"
Playing MPEG stream from two_out_of_three_aint_bad.mp3 ...
MPEG 1.0 layer III, 128 kbit/s, 44100 Hz joint-stereo
ALSA lib pcm_hw.c:549:(snd_pcm_hw_start) SNDRV_PCM_IOCTL_START failed:
Broken pipe
"
and of course I still get no sound.
The /proc/asound/cards file contains
0 [CA0106 ]: CA0106 - CA0106
Live! 7.1 24bit [SB0413] at 0xc8e0 irq 3
Is this card really supported as indicated by the alsa souncards list?
Am I doing something wrong?
How can I fix it or get more information so someone can?
Issue History
Date Modified Username Field Change
======================================================================
12-13-04 09:21 sjberryman New Issue
12-13-04 09:21 sjberryman Distribution => Fedora Core1, Core2
and Suse 9.2
12-13-04 09:21 sjberryman Kernel Version => 2.6.9 2.4.28 2.6.8
12-13-04 09:26 sjberryman Issue Monitored: sjberryman
12-13-04 10:07 pzad Note Added: 0002821
12-16-04 18:28 tiwai Status new => resolved
12-16-04 18:28 tiwai Resolution open => not an issue
12-16-04 18:28 tiwai Assigned To => tiwai
12-16-04 18:28 tiwai Assigned To tiwai =>
01-19-05 09:08 sjberryman Status resolved => feedback
01-19-05 09:08 sjberryman Resolution not an issue => reopened
01-19-05 09:08 sjberryman Note Added: 0003263
01-19-05 14:27 tiwai Note Added: 0003266
01-22-05 22:15 nadavkav Note Added: 0003379
01-22-05 23:20 fmoraes Note Added: 0003381
01-25-05 22:39 Kane32 Note Added: 0003411
01-26-05 13:18 nadavkav Note Added: 0003416
02-08-05 23:26 sHINOBI Issue Monitored: sHINOBI
02-08-05 23:32 sHINOBI Note Added: 0003534
02-09-05 07:25 pzad Note Added: 0003535
02-09-05 08:57 sHINOBI Note Added: 0003536
02-09-05 13:25 nadavkav Issue Monitored: nadavkav
02-09-05 13:25 nadavkav Issue End Monitor: nadavkav
05-28-05 16:06 sjberryman Note Added: 0004774
05-28-05 20:02 jcdutton Status feedback => assigned
05-28-05 20:02 jcdutton Assigned To => jcdutton
======================================================================
-------------------------------------------------------
This SF.Net email is sponsored by Yahoo.
Introducing Yahoo! Search Developer Network - Create apps using Yahoo!
Search APIs Find out how you can build Yahoo! directly into your own
Applications - visit http://developer.yahoo.net/?fr=offad-ysdn-ostg-q22005
next reply other threads:[~2005-05-28 18:02 UTC|newest]
Thread overview: 24+ messages / expand[flat|nested] mbox.gz Atom feed top
2005-05-28 18:02 bugtrack [this message]
-- strict thread matches above, loose matches on Subject: below --
2005-09-10 11:12 [ALSA - driver 0000724]: No apparent support for Creative Sounblaster 24 bit bugtrack
2005-06-13 8:25 bugtrack
2005-06-13 7:33 bugtrack
2005-06-12 13:43 bugtrack
2005-06-11 13:13 bugtrack
2005-06-11 13:11 bugtrack
2005-06-11 11:34 bugtrack
2005-06-10 16:58 bugtrack
2005-06-10 11:28 bugtrack
2005-05-28 18:07 bugtrack
2005-05-28 14:06 bugtrack
2005-02-09 7:57 bugtrack
2005-02-09 6:25 bugtrack
2005-02-08 22:32 bugtrack
2005-01-26 12:18 bugtrack
2005-01-25 21:39 bugtrack
2005-01-22 22:20 bugtrack
2005-01-22 21:15 bugtrack
2005-01-19 13:27 bugtrack
2005-01-19 8:08 bugtrack
2004-12-16 17:28 bugtrack
2004-12-13 9:07 bugtrack
2004-12-13 8:21 bugtrack
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=87d087b58a124c44295addfe18fa19c7@bugtrack.alsa-project.org \
--to=bugtrack@alsa-project.org \
--cc=alsa-devel@alsa-project.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.