Re: [PATCH v13 06/12] usb: xhci: use bus->sysdev for DMA configuration

[Felipe Balbi <balbi@kernel.org>]

[-- Attachment #1: Type: text/plain, Size: 2140 bytes --]


Hi,

Roger Quadros <rogerq@ti.com> writes:
>>>>>>>> Why are we using sysdev to read DT property? We should be using the
>>>>>>>> XHCI device (&pdev->dev) here, no?
>>>>>>>
>>>>>>> If I remember correctly, this is one of the cases where pdev does not
>>>>>>> have a device node attached to it because it was created by the driver
>>>>>>> of the parent device on the fly in case of dwc3. When you have a pure xhci
>>>>>>> device in DT, the two pointers are the same.
>>>>>>
>>>>>> From drivers/usb/dwc3/host.c
>>>>>>
>>>>>>>         if (dwc->usb3_lpm_capable) {
>>>>>>>                 props[0].name = "usb3-lpm-capable";
>>>>>>>                 ret = platform_device_add_properties(xhci, props);
>>>>>>>                 if (ret) {
>>>>>>>                         dev_err(dwc->dev, "failed to add properties to xHCI\n");
>>>>>>>                         goto err1;
>>>>>>>                 }
>>>>>>>         }
>>>>>>
>>>>>> So it is setting the usb3-lpm-capable property into the xhci platform device
>>>>>> and we should be reading the property from there.
>>>>
>>>> Why dwc3 needs another "snps,usb3_lpm_capable"? Why not using
>>>> "usb3-lpm-capable" at firmware directly?
>>>
>>> dwc3 is not setting "snps,usb3_lpm_capable" but "usb3-lpm-capable" for the
>>> xhci platform device.
>>>
>>> What did you mean by firmware? Did you mean something like BIOS?
>>> At least TI platforms don't use any firmware like BIOS. So dwc3 driver
>>> needs to create a platform device for xhci on the fly and set the DT properties.
>>>
>> 
>> By readying code, the dwc3 calls dwc3_get_properties to set
>> dwc->usb3_lpm_capable, and at dwc3/host.c, it sets property
>> "usb3-lpm-capable" according to this flag, why not let common
>> code xhci-plat.c to get this property from sysdev which is DT
>> nodes for dwc3?
>> 
>
> Felipe, any comments?

Won't work. We have quirk flags which are based on DWC3's revision which
is not accessible by xhci-plat. Also, we can't call
device_add_property() because it's not really *adding*. It's *setting*,
meaning that we would loose all other properties.

-- 
balbi

[-- Attachment #2: signature.asc --]
[-- Type: application/pgp-signature, Size: 832 bytes --]