Re: [PATCH v3 2/7] ath10k: add ATH10K_FW_IE_WMI_OP_VERSION

[Kalle Valo <kvalo@qca.qualcomm.com>]

Michal Kazior <michal.kazior@tieto.com> writes:

> On 1 December 2014 at 15:45, Kalle Valo <kvalo@qca.qualcomm.com> wrote:
> [...]
>> @@ -801,11 +812,24 @@ static int ath10k_core_init_firmware_features(struct ath10k *ar)
>>         }
>>
>>         if (test_bit(ATH10K_FW_FEATURE_WMI_10X, ar->fw_features)) {
>> -               ar->max_num_peers = TARGET_10X_NUM_PEERS;
>> -               ar->max_num_stations = TARGET_10X_NUM_STATIONS;
>> +               if (test_bit(ATH10K_FW_FEATURE_WMI_10_2, ar->fw_features))
>> +                       ar->wmi.op_version = ATH10K_FW_WMI_OP_VERSION_10_2;
>> +               else
>> +                       ar->wmi.op_version = ATH10K_FW_WMI_OP_VERSION_10_1;
>>         } else {
>> +               ar->wmi.op_version = ATH10K_FW_WMI_OP_VERSION_MAIN;
>> +       }
>
> You always overwrite ar->wmi.op_version with MAIN if it's not 10.x
> which means TLV is/wiil be effectively overwritten.
>
> Perhaps the op_version enum values should start with 1 so that 0 can
> be used as "unset" and only in that case should the above fallback be
> attempted.

That's a good idea, I'll add that.

> Also, I think it might be a good idea to reset ar->wmi.op_version in
> ath10k_core_fetch_firmware_api_n (and api_1 as well) so that if any
> attempt fails (e.g. due to IE binary corruption) ar->wmi.op_version
> isn't propagated/left unchanged to another fw API attempt.

Yeah, we should do that. But that's an existing problem, not something
introduced by this patchset (we have the same problem with
ar->fw_features) . So I would like to fix that later and added it to the
TODO list:

http://wireless.kernel.org/en/users/Drivers/ath10k/todo

-- 
Kalle Valo

_______________________________________________
ath10k mailing list
ath10k@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/ath10k