Re: [PATCH v1 0/2] riscv: dts: starfive: Enable Bluetooth on JH7100 boards

From: Andreas Schwab <schwab@linux-m68k.org>
To: Emil Renner Berthing <emil.renner.berthing@canonical.com>
Cc: devicetree@vger.kernel.org,  linux-riscv@lists.infradead.org,
	linux-kernel@vger.kernel.org,
	 Emil Renner Berthing <kernel@esmil.dk>,
	Rob Herring <robh@kernel.org>,
	 Krzysztof Kozlowski <krzk+dt@kernel.org>,
	Conor Dooley <conor+dt@kernel.org>,
	 Paul Walmsley <paul.walmsley@sifive.com>,
	 Palmer Dabbelt <palmer@dabbelt.com>,
	 Albert Ou <aou@eecs.berkeley.edu>
Subject: Re: [PATCH v1 0/2] riscv: dts: starfive: Enable Bluetooth on JH7100 boards
Date: Fri, 10 May 2024 11:35:34 +0200	[thread overview]
Message-ID: <87zfsy102h.fsf@igel.home> (raw)
In-Reply-To: <CAJM55Z-F6N6ua5LoqyMFogDtLp=FaRPoDv4osXFDMjR1b8r9nw@mail.gmail.com> (Emil Renner Berthing's message of "Fri, 10 May 2024 04:02:58 -0500")

On Mai 10 2024, Emil Renner Berthing wrote:

> You don't include any information useful for debugging this, but if it get's
> far enough to load the firmware could you at least make sure you run the
> version below, so that's at least the same.
>
> https://github.com/esmil/linux/blob/visionfive/firmware/brcm/BCM43430A1.hcd

That didn't change anything (and there are no messages related to
firmware loading from hci_uart).

[  +0.879623] Bluetooth: Core ver 2.22
[  +0.004843] NET: Registered PF_BLUETOOTH protocol family
[  +0.008787] Bluetooth: HCI device and connection manager initialized
[  +0.021944] Bluetooth: HCI socket layer initialized
[  +0.008488] Bluetooth: L2CAP socket layer initialized
[  +0.006333] Bluetooth: SCO socket layer initialized
[  +0.097478] Bluetooth: HCI UART driver ver 2.3
[  +0.007943] Bluetooth: HCI UART protocol H4 registered
[  +0.006066] Bluetooth: HCI UART protocol BCSP registered
[  +0.006962] Bluetooth: HCI UART protocol LL registered
[  +0.000015] Bluetooth: HCI UART protocol ATH3K registered
[  +0.000084] Bluetooth: HCI UART protocol Three-wire (H5) registered
[  +0.000247] Bluetooth: HCI UART protocol Intel registered
[  +0.000455] Bluetooth: HCI UART protocol Broadcom registered
[  +0.000084] Bluetooth: HCI UART protocol QCA registered
[  +0.000008] Bluetooth: HCI UART protocol AG6XX registered
[  +0.000057] Bluetooth: HCI UART protocol Marvell registered
[  +0.051854] hci_uart_bcm serial0-0: supply vbat not found, using dummy regulator
[  +0.000387] hci_uart_bcm serial0-0: supply vddio not found, using dummy regulator
[  +0.094658] hci_uart_bcm serial0-0: No reset resource, using default baud rate
[  +0.990297] Bluetooth: hci0: command 0x1001 tx timeout
[  +0.022893] Bluetooth: hci0: BCM: Reading local version info failed (-110)
[  +3.306159] Bluetooth: BNEP (Ethernet Emulation) ver 1.3
[  +0.013336] Bluetooth: BNEP filters: protocol multicast
[  +0.124262] Bluetooth: BNEP socket layer initialized

-- 
Andreas Schwab, schwab@linux-m68k.org
GPG Key fingerprint = 7578 EB47 D4E5 4D69 2510  2552 DF73 E780 A9DA AEC1
"And now for something completely different."

_______________________________________________
linux-riscv mailing list
linux-riscv@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-riscv