Re: [PATCH][iproute2] tc/q_htb.c: Fix the MPU value output in 'tc -d class show dev <device_name> ' command

[Dmitrii Shcherbakov <fw.dmitrii@yandex.com>]

Phil,

> Dmitrii, did iproute2 without your change even print the overhead as
set by you before? Looking at the code, I'd assume not.

I used an iproute2 provided by the distribution and an OpenVZ 3.10 kernel
so there are differences there but I
noticed the 'manual' overhead-related code is included there. I am going
to get an upstream kernel and iproute2 to check tomorrow. At least they
print mpu consistently.

The following output is for non-upstream kernels and iproute2 provided
by the distributions so it probably won't be 100% useful to answer your
question.

This is what I have on a quite an old ovz kernel at home:

[root@localhost ~]# uname -r
3.10.0-229.7.2.vz7.8.8
[root@localhost ~]# tc qdisc add dev eth0 root handle 1: htb default 12
[root@localhost ~]# tc class add dev eth0 parent 1: classid 1:1 htb rate
100kbps ceil 100kbps mpu 256 overhead 64
[root@localhost ~]# tc -d class show dev eth0
class htb 1:1 root prio 0 quantum 10000 rate 800000bit overhead 64 ceil
800000bit burst 1600b/1 mpu 0b overhead 1b cburst 1600b/1 mpu 0b
overhead 1b level 0

And this is the same on ubuntu 14.04 with 3.19 kernel (looks like the
mpu value is not configured properly which is strange, though 'manual'
overhead is there).

administrator@ubuntu-q87:~$ uname -r
3.19.0-33-generic

administrator@ubuntu-q87:~$ sudo tc qdisc add dev eth0 root handle 1:
htb default 12
administrator@ubuntu-q87:~$ sudo tc class add dev eth0 parent 1: classid
1:1 htb rate 100kbps ceil 100kbps mpu 256 overhead 64
administrator@ubuntu-q87:~$ tc -d class show dev eth0
class htb 1:1 root prio 0 quantum 10000 rate 800000bit overhead 64 ceil
800000bit linklayer ethernet burst 1600b/1 mpu 0b overhead 0b cburst
1600b/1 mpu 0b overhead 0b level 0

Thanks,
Dima