ath10k-firmware: QCA988X hw2.0: Add TP-Link OnHub BDF

ath10k-firmware: QCA988X hw2.0: Add TP-Link OnHub BDF

[Brian Norris]

[-- Attachment #1: Type: text/plain, Size: 1303 bytes --]

Hi,

In preparing OpenWrt support for the TP-Link OnHub, I've extracted its
BDF for inclusion in the mainline board-2.bin.

Per the wiki [1]:

 * description for what hardware this is

   - IPQ8064-based router, with three radios -- a 2.4 GHz, a 5 GHz, and
     an auxiliary (monitoring?) radio
   - There are two variants of the OnHub: one by TP-Link, and one by
     ASUS. The TP-Link version of the OnHub [2] was released first, and
     the ASUS variant (ASUS OnHub SRT-AC1900) seems to use the same BDF.
     I use the first product when choosing the variant name.

 * origin of the board file (did you create it yourself or where you
   downloaded)

   - Pulled from the factory device filesystem for TP-Link OnHub, and
     compared with the ASUS filesystem.

 * ids to be used with the board file (ATH10K_BD_IE_BOARD_NAME in ath10k) +
   md5sum of each new board file to add

   - QCA988X hw2.0

     BoardNames[0]: 'bus=pci,vendor=168c,device=003c,subsystem-vendor=0000,subsystem-device=0000,variant=tplink,onhub'
     BoardMD5[0]: ab36ef267d15cfc02317ceeb38e8f548

Attached filename matches the ID above, with a '.bin' suffix appended.

Regards,
Brian

[1] https://wireless.wiki.kernel.org/en/users/drivers/ath10k/boardfiles
[2] https://www.tp-link.com/us/home-networking/wifi-router/tgr1900/

[-- Attachment #2: bus=pci,vendor=168c,device=003c,subsystem-vendor=0000,subsystem-device=0000,variant=tplink,onhub.bin --]
[-- Type: application/octet-stream, Size: 2116 bytes --]

[-- Attachment #3: Type: text/plain, Size: 146 bytes --]

_______________________________________________
ath10k mailing list
ath10k@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/ath10k

Re: ath10k-firmware: QCA988X hw2.0: Add TP-Link OnHub BDF

[Brian Norris]

On Fri, Dec 30, 2022 at 10:51:28PM -0800, Brian Norris wrote:
> In preparing OpenWrt support for the TP-Link OnHub, I've extracted its
> BDF for inclusion in the mainline board-2.bin.

Apologies, I just realized that:
(a) QCA988X devices have a board.bin file upstream, not a board-2.bin.
(b) They're all using the same board.bin file. (And, the one I pulled
    from the TP-Link filesystem is the same as the upstream one.)

So ignore this one. Sorry for the noise.

Brian

_______________________________________________
ath10k mailing list
ath10k@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/ath10k