Re: [net-next: PATCH v3 4/6] net: mvmdio: add ACPI support

[Andrew Lunn <andrew@lunn.ch>]

On Wed, Jun 23, 2021 at 11:58:14PM +0200, Marcin Wojtas wrote:
> śr., 23 cze 2021 o 22:28 Andrew Lunn <andrew@lunn.ch> napisał(a):
> >
> > On Mon, Jun 21, 2021 at 07:30:26PM +0200, Marcin Wojtas wrote:
> > > This patch introducing ACPI support for the mvmdio driver by adding
> > > acpi_match_table with two entries:
> > >
> > > * "MRVL0100" for the SMI operation
> > > * "MRVL0101" for the XSMI mode
> >
> > Same as the freescale MDIO bus driver, you should add
> >
> > depends on FWNODE_MDIO
> >
> > Otherwise you might find randconfig builds end up with it disabled,
> > and then linker errors.
> >
> 
> The CONFIG_MVMDIO is selected by CONFIG_MV643XX_ETH and actually there
> is a real example of the previously discussed fallback to the
> mdiobus_register() (without DT/ACPI and now FWNODE_MDIO). I just
> checked and successfully built the kernel out of the dove_defconfig. I
> only needed below fix, that will be submitted in v4:

You could be correct, but i've seen randconfig builds find issues. So
i tend to add dependencies to avoid possible problems.  Such problem
reports tend to come weeks later, when Arnd does such builds.

	Andrew