Re: [RFC PATCH v3 1/8] leds: add support for hardware driven LEDs

[Andrew Lunn <andrew@lunn.ch>]

On Tue, Nov 09, 2021 at 03:26:01AM +0100, Ansuel Smith wrote:
> Some LEDs can be driven by hardware (for example a LED connected to
> an ethernet PHY or an ethernet switch can be configured to blink on
> activity on the network, which in software is done by the netdev trigger).
> 
> To do such offloading, LED driver must support this and a supported
> trigger must be used.
> 
> LED driver should declare the correct blink_mode supported and should set
> the blink_mode parameter to one of HARDWARE_CONTROLLED or
> SOFTWARE_HARDWARE_CONTROLLED.
> The trigger will check this option and fail to activate if the blink_mode
> is not supported. By default if a LED driver doesn't declare blink_mode,
> SOFTWARE_CONTROLLED is assumed.
> 
> The LED must implement 3 main API:
> - trigger_offload_status(): This asks the LED driver if offload mode is
>     enabled or not.
>     Triggers will check if the offload mode is supported and will be
>     activated accordingly. If the trigger can't run in software mode,
>     return -EOPNOTSUPP as the blinking can't be simulated by software.

I don't understand this last part. The LED controller is not
implementing software mode, other than providing a method to manually
turn the LED on and off. And there is a well defined call for that. If
that call is a NULL, it is clear it is not implemented. There is no
need to ask the driver.

     Andrew