From: Abdel Alkuor <alkuor@gmail.com>
To: Heikki Krogerus <heikki.krogerus@linux.intel.com>
Cc: krzysztof.kozlowski+dt@linaro.org, bryan.odonoghue@linaro.org,
gregkh@linuxfoundation.org, robh+dt@kernel.org,
linux-usb@vger.kernel.org, devicetree@vger.kernel.org,
conor+dt@kernel.org, linux-kernel@vger.kernel.org,
abdelalkuor@geotab.com
Subject: Re: [PATCH v5 05/15] USB: typec: Check for EEPROM present
Date: Wed, 20 Sep 2023 10:47:38 -0400 [thread overview]
Message-ID: <ZQsGChGBq93Rh35U@primary> (raw)
In-Reply-To: <ZQhGUKocVc+yjOVL@kuha.fi.intel.com>
On Mon, Sep 18, 2023 at 03:45:04PM +0300, Heikki Krogerus wrote:
> On Sun, Sep 17, 2023 at 11:26:29AM -0400, Abdel Alkuor wrote:
> > From: Abdel Alkuor <abdelalkuor@geotab.com>
> >
> > When an EEPROM is present, tps25750 loads the binary configuration from
> > EEPROM. Hence, all we need to do is wait for the device to switch to APP
> > mode
> >
> > Signed-off-by: Abdel Alkuor <abdelalkuor@geotab.com>
> > ---
> > drivers/usb/typec/tipd/core.c | 13 +++++++++++++
> > drivers/usb/typec/tipd/tps6598x.h | 3 +++
> > 2 files changed, 16 insertions(+)
> >
> > diff --git a/drivers/usb/typec/tipd/core.c b/drivers/usb/typec/tipd/core.c
> > index fea139c72d6d..b3d4b2b5bf5f 100644
> > --- a/drivers/usb/typec/tipd/core.c
> > +++ b/drivers/usb/typec/tipd/core.c
> > @@ -37,6 +37,7 @@
> > #define TPS_REG_STATUS 0x1a
> > #define TPS_REG_SYSTEM_CONF 0x28
> > #define TPS_REG_CTRL_CONF 0x29
> > +#define TPS_REG_BOOT_STATUS 0x2D
> > #define TPS_REG_POWER_STATUS 0x3f
> > #define TPS_REG_RX_IDENTITY_SOP 0x48
> > #define TPS_REG_DATA_STATUS 0x5f
> > @@ -897,6 +898,17 @@ static int tps25750_apply_patch(struct tps6598x *tps)
> > int ret;
> > unsigned long timeout;
> > u8 mode;
> > + u64 status = 0;
> > +
> > + ret = tps6598x_block_read(tps, TPS_REG_BOOT_STATUS, &status, 5);
> > + if (ret)
> > + return ret;
> > + /*
> > + * Nothing to be done if the configuration
> > + * is being loaded from EERPOM
> > + */
> > + if (status & TPS25750_BOOT_STATUS_I2C_EEPROM_PRESENT)
> > + goto wait_for_app;
> >
> > ret = tps25750_start_patch_burst_mode(tps);
> > if (ret) {
> > @@ -908,6 +920,7 @@ static int tps25750_apply_patch(struct tps6598x *tps)
> > if (ret)
> > return ret;
> >
> > +wait_for_app:
> > timeout = jiffies + msecs_to_jiffies(1000);
> >
> > do {
> > diff --git a/drivers/usb/typec/tipd/tps6598x.h b/drivers/usb/typec/tipd/tps6598x.h
> > index 527857549d69..5e942c089c27 100644
> > --- a/drivers/usb/typec/tipd/tps6598x.h
> > +++ b/drivers/usb/typec/tipd/tps6598x.h
> > @@ -199,4 +199,7 @@
> > #define TPS_DATA_STATUS_DP_SPEC_PIN_ASSIGNMENT_A BIT(2)
> > #define TPS_DATA_STATUS_DP_SPEC_PIN_ASSIGNMENT_B (BIT(2) | BIT(1))
> >
> > +/* BOOT STATUS REG*/
> > +#define TPS25750_BOOT_STATUS_I2C_EEPROM_PRESENT BIT(3)
>
> That's not TPS25750 specific bit, so please rename that to
> TPS_BOOT_STATUS_I2C_EEPROM_PRESENT
>
I will fix it in v6.
> thanks,
>
> --
> heikki
Thanks,
Abdel
next prev parent reply other threads:[~2023-09-20 15:01 UTC|newest]
Thread overview: 37+ messages / expand[flat|nested] mbox.gz Atom feed top
2023-09-17 15:26 [PATCH v5 00/15] Add TPS25750 USB type-C PD controller support Abdel Alkuor
2023-09-17 15:26 ` [PATCH v5 01/15] dt-bindings: usb: tps6598x: Add tps25750 Abdel Alkuor
2023-09-17 17:30 ` Krzysztof Kozlowski
2023-09-17 19:30 ` Abdel Alkuo
2023-09-17 15:26 ` [PATCH v5 02/15] USB: typec: Add cmd timeout and response delay Abdel Alkuor
2023-09-18 10:44 ` Heikki Krogerus
2023-09-20 14:29 ` Abdel Alkuor
2023-09-17 15:26 ` [PATCH v5 03/15] USB: typec: Add patch mode to tps6598x Abdel Alkuor
2023-09-18 11:07 ` Heikki Krogerus
2023-09-20 14:42 ` Abdel Alkuor
2023-09-17 15:26 ` [PATCH v5 04/15] USB: typec: Load TPS25750 patch bundle Abdel Alkuor
2023-09-17 17:04 ` kernel test robot
2023-09-17 17:24 ` kernel test robot
2023-09-18 11:31 ` Heikki Krogerus
2023-09-20 14:46 ` Abdel Alkuor
2023-09-17 15:26 ` [PATCH v5 05/15] USB: typec: Check for EEPROM present Abdel Alkuor
2023-09-18 12:45 ` Heikki Krogerus
2023-09-20 14:47 ` Abdel Alkuor [this message]
2023-09-17 15:26 ` [PATCH v5 06/15] USB: typec: Clear dead battery flag Abdel Alkuor
2023-09-17 15:26 ` [PATCH v5 07/15] USB: typec: Apply patch again after power resume Abdel Alkuor
2023-09-17 15:26 ` [PATCH v5 08/15] USB: typec: Add interrupt support for TPS25750 Abdel Alkuor
2023-09-18 12:46 ` Heikki Krogerus
2023-09-20 14:50 ` Abdel Alkuor
2023-09-17 15:26 ` [PATCH v5 09/15] USB: typec: Refactor tps6598x port registration Abdel Alkuor
2023-09-17 15:26 ` [PATCH v5 10/15] USB: typec: Add port registration for tps25750 Abdel Alkuor
2023-09-18 12:58 ` Heikki Krogerus
2023-09-20 14:53 ` Abdel Alkuor
2023-09-17 15:26 ` [PATCH v5 11/15] USB: typec: Enable sleep mode " Abdel Alkuor
2023-09-17 17:32 ` Krzysztof Kozlowski
2023-09-17 15:26 ` [PATCH v5 12/15] USB: typec: Add trace for tps25750 irq Abdel Alkuor
2023-09-17 15:26 ` [PATCH v5 13/15] USB: typec: Add power status trace for tps25750 Abdel Alkuor
2023-09-17 15:26 ` [PATCH v5 14/15] USB: typec: Add " Abdel Alkuor
2023-09-17 15:26 ` [PATCH v5 15/15] USB: typec: Do not check VID " Abdel Alkuor
2023-09-18 13:29 ` Heikki Krogerus
2023-09-20 15:10 ` Abdel Alkuor
2023-09-18 13:57 ` [PATCH v5 00/15] Add TPS25750 USB type-C PD controller support Heikki Krogerus
2023-09-20 15:21 ` Abdel Alkuor
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=ZQsGChGBq93Rh35U@primary \
--to=alkuor@gmail.com \
--cc=abdelalkuor@geotab.com \
--cc=bryan.odonoghue@linaro.org \
--cc=conor+dt@kernel.org \
--cc=devicetree@vger.kernel.org \
--cc=gregkh@linuxfoundation.org \
--cc=heikki.krogerus@linux.intel.com \
--cc=krzysztof.kozlowski+dt@linaro.org \
--cc=linux-kernel@vger.kernel.org \
--cc=linux-usb@vger.kernel.org \
--cc=robh+dt@kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.