Re: [PATCH v3 1/1] PCI/ERR: Fix reset logic in pcie_do_recovery() call

[Sinan Kaya <okaya@kernel.org>]

On 9/27/2020 10:43 PM, Kuppuswamy, Sathyanarayanan wrote:
> FATAL + no-hotplug - In this case, link will still be reseted. But
> currently driver state is not properly restored. So I attempted
> to restore it using pci_reset_bus().
> 
>          status = reset_link(dev);
> -        if (status != PCI_ERS_RESULT_RECOVERED) {
> +        if (status == PCI_ERS_RESULT_RECOVERED) {
> +            status = PCI_ERS_RESULT_NEED_RESET;
> 
> ...
> 
>      if (status == PCI_ERS_RESULT_NEED_RESET) {
>          /*
> -         * TODO: Should call platform-specific
> -         * functions to reset slot before calling
> -         * drivers' slot_reset callbacks?
> +         * TODO: Optimize the call to pci_reset_bus()
> +         *
> +         * There are two components to pci_reset_bus().
> +         *
> +         * 1. Do platform specific slot/bus reset.
> +         * 2. Save/Restore all devices in the bus.
> +         *
> +         * For hotplug capable devices and fatal errors,
> +         * device is already in reset state due to link
> +         * reset. So repeating platform specific slot/bus
> +         * reset via pci_reset_bus() call is redundant. So
> +         * can optimize this logic and conditionally call
> +         * pci_reset_bus().
>           */
> +        pci_reset_bus(dev);

I think we have to go to remove/rescan for this case as you also
mentioned above. There is no state to save. All BAR assignments
are gone. Entire device programming is also lost.

I don't think pci_reset_bus() can recover from this situation safely.
It will make things worse by saving/restoring the hardware default
state.

This should remove/rescan logic should be inside DPC's slot_reset()
function BTW. Not here.