Re: [RFC PATCH v2 0/9] Fixes and enhancements for the bmp280 driver

[Andy Shevchenko <andriy.shevchenko@intel.com>]

On Sun, Aug 10, 2025 at 08:58:37PM +0200, Achim Gratz wrote:
> Revision History:
> =================
> 
> v1:
> 	- initial proposal, incorrectly prefixed "bmp280" instead of "RFC PATCH"
> 	- patch series presented in the order it was created
> 
> v1 -> v2:
> 	- prefix as "RFC PATCH"
> 	- drop channel switching
> 	- rewrite to present patches in smaller units and in logical steps

Do not reuse the same email thread for a new version: The rule of thumb -- new
version implies new independent email thread.

> With v6.13 a change was made to the bmp280 drivers to use MODE_FORCED
> instead of MODE_NORMAL.  This broke userspace functionality: reading
> from sysfs interfaces no longer worked and an error was thrown
> "Measurement cycle didn't complete".  This series fixes the underlying
> bugs affecting the measurement time calculation and implements
> additional functionality not available for the BMx280 devices
> previously to allow the use of the sysfs interface in MODE_NORMAL
> again and control the corresponding parameters.  The implementation
> follows the already existing facilities for the BMx[35]80 devices even
> though the actual functionality of the BMx280 devices is slightly
> different.

-- 
With Best Regards,
Andy Shevchenko