From: Jacopo Mondi <jacopo.mondi@ideasonboard.com>
To: Dave Stevenson <dave.stevenson@raspberrypi.com>
Cc: Tianshu Qiu <tian.shu.qiu@intel.com>,
Sakari Ailus <sakari.ailus@linux.intel.com>,
Mauro Carvalho Chehab <mchehab@kernel.org>,
linux-media@vger.kernel.org, linux-kernel@vger.kernel.org,
David Heidelberg <david@ixit.cz>,
20260414-imx355-24mhz-v1-1-9ae77bc6e7ec@ixit.cz
Subject: Re: [PATCH 08/13] media: imx355: pixel_rate never changes, so don't recompute
Date: Thu, 7 May 2026 16:13:32 +0200 [thread overview]
Message-ID: <afyeAi9VD4iKRFw1@zed> (raw)
In-Reply-To: <20260506-media-imx355-v1-8-660685030455@raspberrypi.com>
Hi Dave
On Wed, May 06, 2026 at 07:23:46PM +0100, Dave Stevenson wrote:
> The pixel rate is always the same, so there is no need to try and
> recompute it in imx355_set_pad_format, and then no need to have the
> pointer to it stored.
>
> Signed-off-by: Dave Stevenson <dave.stevenson@raspberrypi.com>
Reviewed-by: Jacopo Mondi <jacopo.mondi@ideasonboard.com>
> ---
> drivers/media/i2c/imx355.c | 10 ++--------
> 1 file changed, 2 insertions(+), 8 deletions(-)
>
> diff --git a/drivers/media/i2c/imx355.c b/drivers/media/i2c/imx355.c
> index b0cddb614775..12005bc40f36 100644
> --- a/drivers/media/i2c/imx355.c
> +++ b/drivers/media/i2c/imx355.c
> @@ -161,7 +161,6 @@ struct imx355 {
> struct v4l2_ctrl_handler ctrl_handler;
> /* V4L2 Controls */
> struct v4l2_ctrl *link_freq;
> - struct v4l2_ctrl *pixel_rate;
> struct v4l2_ctrl *vblank;
> struct v4l2_ctrl *hblank;
> struct v4l2_ctrl *exposure;
> @@ -860,7 +859,6 @@ imx355_set_pad_format(struct v4l2_subdev *sd,
> s32 vblank_def;
> s32 vblank_min;
> s64 h_blank;
> - u64 pixel_rate;
> u32 height;
>
> mutex_lock(&imx355->mutex);
> @@ -881,9 +879,6 @@ imx355_set_pad_format(struct v4l2_subdev *sd,
> *framefmt = fmt->format;
> } else {
> imx355->cur_mode = mode;
> - pixel_rate = IMX355_LINK_FREQ_DEFAULT * 2 * 4;
> - do_div(pixel_rate, 10);
> - __v4l2_ctrl_s_ctrl_int64(imx355->pixel_rate, pixel_rate);
> /* Update limits and set FPS to default */
> height = imx355->cur_mode->height;
> vblank_def = imx355->cur_mode->fll_def - height;
> @@ -1175,9 +1170,8 @@ static int imx355_init_controls(struct imx355 *imx355)
> pixel_rate = IMX355_LINK_FREQ_DEFAULT * 2 * 4;
> do_div(pixel_rate, 10);
> /* By default, PIXEL_RATE is read only */
> - imx355->pixel_rate = v4l2_ctrl_new_std(ctrl_hdlr, &imx355_ctrl_ops,
> - V4L2_CID_PIXEL_RATE, pixel_rate,
> - pixel_rate, 1, pixel_rate);
> + v4l2_ctrl_new_std(ctrl_hdlr, &imx355_ctrl_ops, V4L2_CID_PIXEL_RATE,
> + pixel_rate, pixel_rate, 1, pixel_rate);
>
> /* Initialize vblank/hblank/exposure parameters based on current mode */
> mode = imx355->cur_mode;
>
> --
> 2.34.1
>
>
next prev parent reply other threads:[~2026-05-07 14:13 UTC|newest]
Thread overview: 31+ messages / expand[flat|nested] mbox.gz Atom feed top
2026-05-06 18:23 [PATCH 00/13] media/imx355: General code cleanups, and adding support for 2 lane operation Dave Stevenson
2026-05-06 18:23 ` [PATCH 01/13] media: imx355: Remove duplicated registers from the mode tables Dave Stevenson
2026-05-07 13:41 ` Jacopo Mondi
2026-05-06 18:23 ` [PATCH 02/13] media: imx355: Remove setting FRM_LENGTH_LINES in the mode regs Dave Stevenson
2026-05-07 13:50 ` Jacopo Mondi
2026-05-06 18:23 ` [PATCH 03/13] media: imx355: Programmatically set the crop parameters for each mode Dave Stevenson
2026-05-07 14:00 ` Jacopo Mondi
2026-05-07 16:01 ` Dave Stevenson
2026-05-06 18:23 ` [PATCH 04/13] media: imx355: Remove the duplication between width/height and x/y_out_size Dave Stevenson
2026-05-06 18:23 ` [PATCH 05/13] media: imx355: Set register LINE_LENGTH_PCK programmatically Dave Stevenson
2026-05-07 14:09 ` Jacopo Mondi
2026-05-07 15:18 ` Dave Stevenson
2026-05-06 18:23 ` [PATCH 06/13] media: imx355: Set binning mode registers programmatically Dave Stevenson
2026-05-07 14:12 ` Jacopo Mondi
2026-05-06 18:23 ` [PATCH 07/13] media: imx355: Remove link_freq_index from each mode as ununsed Dave Stevenson
2026-05-07 14:12 ` Jacopo Mondi
2026-05-06 18:23 ` [PATCH 08/13] media: imx355: pixel_rate never changes, so don't recompute Dave Stevenson
2026-05-07 14:13 ` Jacopo Mondi [this message]
2026-05-06 18:23 ` [PATCH 09/13] media: imx355: Remove redundant fll_min, and implement fixed offset Dave Stevenson
2026-05-07 14:29 ` Jacopo Mondi
2026-05-07 15:21 ` Dave Stevenson
2026-05-06 18:23 ` [PATCH 10/13] media: imx355: Add support for get_selection Dave Stevenson
2026-05-07 14:42 ` Jacopo Mondi
2026-05-07 15:02 ` Dave Stevenson
2026-05-06 18:23 ` [PATCH 11/13] media: imx355: Use pm_runtime autosuspend_delay Dave Stevenson
2026-05-07 14:43 ` Jacopo Mondi
2026-05-06 18:23 ` [PATCH 12/13] media: imx355: Convert to new CCI register access helpers Dave Stevenson
2026-05-07 14:49 ` Jacopo Mondi
2026-05-06 18:23 ` [PATCH 13/13] media: imx355: Support 2 lane readout Dave Stevenson
2026-05-13 18:33 ` Richard Acayan
2026-05-14 10:37 ` Dave Stevenson
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=afyeAi9VD4iKRFw1@zed \
--to=jacopo.mondi@ideasonboard.com \
--cc=20260414-imx355-24mhz-v1-1-9ae77bc6e7ec@ixit.cz \
--cc=dave.stevenson@raspberrypi.com \
--cc=david@ixit.cz \
--cc=linux-kernel@vger.kernel.org \
--cc=linux-media@vger.kernel.org \
--cc=mchehab@kernel.org \
--cc=sakari.ailus@linux.intel.com \
--cc=tian.shu.qiu@intel.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.