Re: [PATCH] ASoC: cs42xx8: Add SPI bus support for CS42448/CS42888 codec

[Charles Keepax <ckeepax@opensource.cirrus.com>]

On Mon, Jun 01, 2026 at 05:02:24PM +0900, chancel.liu@oss.nxp.com wrote:
> From: Chancel Liu <chancel.liu@nxp.com>
> 
> The existing cs42xx8 driver only supported I2C control interface.
> Add SPI bus support for the Cirrus Logic CS42448/CS42888 Audio CODEC.
> 
> Signed-off-by: Chancel Liu <chancel.liu@nxp.com>
> +static int cs42xx8_spi_probe(struct spi_device *spi)
> +{
> +	struct cs42xx8_driver_data *drvdata;
> +	struct regmap_config config;
> +	int ret;
> +
> +	drvdata = (struct cs42xx8_driver_data *)spi_get_device_match_data(spi);
> +	if (!drvdata)
> +		return dev_err_probe(&spi->dev, -EINVAL,
> +				     "failed to find driver data\n");
> +
> +	config = cs42xx8_regmap_config;
> +	/*
> +	 * reg_bits=16 makes regmap send a 2-byte address field (big-endian).
> +	 * write_flag_mask/read_flag_mask are OR'd into that address field:
> +	 */
> +	config.reg_bits           = 16;
> +	config.write_flag_mask    = 0x9E;
> +	config.read_flag_mask     = 0x9F;
> +	config.reg_format_endian  = REGMAP_ENDIAN_BIG;

Probably nicer to just update cs42xx8_regmap_config for the
endian, I believe this part is the same on both buses?

Otherwise looks fine to me.

Thanks,
Charles