Re: [PATCH v3 4/5] pinctrl: freescale: add the LX2160A RCW pad-mux driver

[Vincent Jardin <vjardin@free.fr>]

Hi Frank,

Le 08/11/26 11:06, Vincent Jardin via B4 Relay a écrit :
> From: Vincent Jardin <vjardin@free.fr>
> 
> The LX2160A muxes its IIC, XSPI, SDHC, UART, IRQ and EVT pads from
> fields of the RCW, read-only in RCWSR12..14 of DCFG and changed at
> runtime through the same fields of the override registers in its DCSR
> view, which read 0 until written.
> 
> Since commit 8a1365c7bbc1 ("arm64: dts: lx2160a: add pinmux and i2c
> gpio to support bus recovery") Linux drives them with pinctrl-single on
> the override registers, so its first pin state clears every other field
> of the word: a board whose RCW programs a non-zero pad mux loses those
> pads at the first I2C probe.
> 
> Add a driver for the pad mux as a child of the DCFG node: the fields
> of RCWSR12..14 and their encoding.
> Then pin states select them with the generic function and groups
> properties, and every change goes through the RCW override
> of fsl-guts, which reads the status register, writes the override and
> waits for the status register to follow.

Following the review on the patch 1 and 2, then can I have your advise
on this topic ?

I am looking for the review of this serie, then I'll adapt it
for u-boot along with the integration of Linux.

best regards,
  Vincent