[PATCH v2 1/2] wifi: rtw88: 8822c: Fix reported RX band width

[Bitterblue Smith <rtl8821cerfe2@gmail.com>]

"iw dev wlp2s0 station dump" shows incorrect rx bitrate:

tx bitrate:     866.7 MBit/s VHT-MCS 9 80MHz short GI VHT-NSS 2
rx bitrate:     86.7 MBit/s VHT-MCS 9 VHT-NSS 1

This is because the RX band width is calculated incorrectly. Fix the
calculation according to the phydm_rxsc_2_bw() function from the
official drivers.

After:

tx bitrate:     866.7 MBit/s VHT-MCS 9 80MHz short GI VHT-NSS 2
rx bitrate:     390.0 MBit/s VHT-MCS 9 80MHz VHT-NSS 1

It also works correctly with the AP configured for 20 MHz and 40 MHz.

Tested with RTL8822CE.

Fixes: e3037485c68e ("rtw88: new Realtek 802.11ac driver")
Signed-off-by: Bitterblue Smith <rtl8821cerfe2@gmail.com>
---
v2:
 - Use Fixes instead of Cc: stable.
---
 drivers/net/wireless/realtek/rtw88/rtw8822c.c | 10 ++++++----
 1 file changed, 6 insertions(+), 4 deletions(-)

diff --git a/drivers/net/wireless/realtek/rtw88/rtw8822c.c b/drivers/net/wireless/realtek/rtw88/rtw8822c.c
index bc807b13e9ce..e265a35184ab 100644
--- a/drivers/net/wireless/realtek/rtw88/rtw8822c.c
+++ b/drivers/net/wireless/realtek/rtw88/rtw8822c.c
@@ -2612,12 +2612,14 @@ static void query_phy_status_page1(struct rtw_dev *rtwdev, u8 *phy_status,
 	else
 		rxsc = GET_PHY_STAT_P1_HT_RXSC(phy_status);
 
-	if (rxsc >= 9 && rxsc <= 12)
+	if (rxsc == 0)
+		bw = rtwdev->hal.current_band_width;
+	else if (rxsc >= 1 && rxsc <= 8)
+		bw = RTW_CHANNEL_WIDTH_20;
+	else if (rxsc >= 9 && rxsc <= 12)
 		bw = RTW_CHANNEL_WIDTH_40;
-	else if (rxsc >= 13)
-		bw = RTW_CHANNEL_WIDTH_80;
 	else
-		bw = RTW_CHANNEL_WIDTH_20;
+		bw = RTW_CHANNEL_WIDTH_80;
 
 	channel = GET_PHY_STAT_P1_CHANNEL(phy_status);
 	rtw_set_rx_freq_band(pkt_stat, channel);
-- 
2.45.2