Re: [LARTC] Re: further CBQ/tc documentation ds9a.nl/lartc/manpages

[jamal <hadi@cyberus.ca>]

Hi,
This is definetely a bug; Is this with diffserv turned on in
iproute2/Config?
What version of iproute2 (not that it makes much of a difference)

cheers,
jamal

On Sun, 9 Dec 2001, Henrik Nordstrom wrote:

> You need to specify the correct arguments to the qdisc you are adding.. I.e.
> the same command as adding that qdisc as the root qdisc, but replace root by
> ingress.
>
> tc qdisc add dev eth0 ingress tbf rate 220kbit latency 50ms burst 1540
>
> qdisc tbf ffff: dev eth0 rate 220Kbit burst 1407b lat 2147.5s
>  Sent 0 bytes 0 pkts (dropped 0, overlimits 0)
>
> But as I said it does not seem to ever be used.
>
> Regards
> Henrik
>
> On Sunday 09 December 2001 03.30, jamal wrote:
> > On Sun, 9 Dec 2001, Henrik Nordstrom wrote:
> > > to ingress. Have not yet figured out if this actually can be used for
> > > anything.
> > >
> > >    tc qdisc add dev eth0 ingress tbf ....
> > >    (or any other qdisc)
> > >
> > > is happily accepted but afaict does not seem to have any function..
> >
> > I cant seem to get it to work;
> > -------
> > [root@jzny tc]# ./tc qdisc add dev lo handle ffff: ingress tbf
> > RTNETLINK answers: Invalid argument
> > [root@jzny tc]# ./tc qdisc add dev lo handle ffff: ingress
> > [root@jzny tc]# tc -s qdisc
> > qdisc ingress ffff: dev lo
> >  Sent 0 bytes 0 pkts (dropped 0, overlimits 0)
> > --------
> >
> > What is the full command?
> > can you try tc -s qdisc after you add it ?
> >
> > cheers,
> > jamal
>


_______________________________________________
LARTC mailing list / LARTC@mailman.ds9a.nl
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://ds9a.nl/lartc/