Fw: [LARTC] Combining ingress and egress ( IMQ+HTB)

["Rajesh Srivastava" <rajesh@balcomt.com>]

[LARTC] Combining ingress and egress ( IMQ+HTB)I checked the guide and you
are right about it. However, I cannot get it to work,
if I remove egress qdisc the traffic stops following any rules.

Has anyone done this successfully before? Any pointers are welcome.

Thanks
Rajesh
------------------------------------
The way I understand it is summed up in a quote from "LEAF Bering user's
guide"

---
In many cases like those of ISPs, the bandwidth allocation is for incoming
and
outgoing combined. Under such situations, in stock linux, a virtual device
called IMQ has been created through which all traffic passes. Thus shaping
on
IMQ will enable shaping total traffic and not incoming and outgoing
separately.
---

On Wednesday June 25 2003 02:37 pm, Rajesh Srivastava wrote:
> I am successfully running ingress (IMQ) and egress (HTB) shaping on a
> bridge.
>
> Is there any way to combine and share the bandwidth between ingress and
> egress?
>
> Example:
> I have set up www service for egress at 128 KB and ingress at 256 KB. The
> shaping on them works fine separately. However, I want to create a single
> virtual pipe for www traffic and limit both ingress and egress combined to
> 256 KB.
>
> Thanks.
>
> Rajesh
>
>
> _______________________________________________
> LARTC mailing list / LARTC@mailman.ds9a.nl
> http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/

--
Regards

Joseph Watson


_______________________________________________
LARTC mailing list / LARTC@mailman.ds9a.nl
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/