[LARTC] Getting RTNETLINK answers: No such file or directory messages

[LARTC] Getting RTNETLINK answers: No such file or directory messages

[Yusuf Goolamabbas]

Hi, I am running Linux 2.2.19 on a RH 7.0 box with iproute-2.2.4-7
installed via RH's stock rpm

This is the relevant section of my config file

CONFIG_NET_SCHED=y
CONFIG_NETLINK=y
CONFIG_RTNETLINK=y
CONFIG_NET_SCH_CBQ=y
# CONFIG_NET_SCH_CSZ is not set
# CONFIG_NET_SCH_PRIO is not set
# CONFIG_NET_SCH_RED is not set
# CONFIG_NET_SCH_SFQ is not set
# CONFIG_NET_SCH_TEQL is not set
# CONFIG_NET_SCH_TBF is not set
CONFIG_NET_QOS=y
CONFIG_NET_ESTIMATOR=y
CONFIG_NET_CLS=y
CONFIG_NET_CLS_ROUTE4=y
CONFIG_NET_CLS_ROUTE=y
CONFIG_NET_CLS_FW=y
CONFIG_NET_CLS_U32=y
# CONFIG_NET_CLS_RSVP is not set
# CONFIG_NET_CLS_RSVP6 is not set
CONFIG_NET_CLS_POLICE=y

When I try to run the example as show in the Advanced Routing example,

tc qdisc add dev eth0 handle 10: cbq bandwidth 10Mbit avpkt 1000 

I get

RTNETLINK answers: No such file or directory

Is there something I might have missed 

Regards, Yusuf

-- 
Yusuf Goolamabbas
yusufg@outblaze.com

_______________________________________________
LARTC mailing list / LARTC@mailman.ds9a.nl
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://ds9a.nl/2.4Routing/

Re: [LARTC] Getting RTNETLINK answers: No such file or directory messages

[Rodrigo Goya]

Hello,

> tc qdisc add dev eth0 handle 10: cbq bandwidth 10Mbit avpkt 1000 

You missed "root":

tc qdisc add dev eth0 root handle 10: cbq bandwidth 10Mbit avpkt 1000
		     ^^^^^^
Cheers,

Rodrigo Goya

_______________________________________________
LARTC mailing list / LARTC@mailman.ds9a.nl
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://ds9a.nl/2.4Routing/