[B.A.T.M.A.N.] about mesh network with batman-adv

[B.A.T.M.A.N.] about mesh network with batman-adv

[KwangMin Kim]

Hi, 

I set up a wireless mesh network by setting batman-adv on three Raspberry pies. 

There was no problem communicating with each other. (ping, iperf check completed)

However, I have disabled one of these batman-adv settings and rejoined the wireless mesh network. 

As a result, only two raspberry pies that have set up batman-adv communicate.

is this right?

If so, how do I configure it so that non-batman-adv nodes and nodes with batman-adv enabled communicate with each other?


Best regards.

---
Kwang-Min Kim(kim25444@naver.com)
+821055216393

Re: [B.A.T.M.A.N.] about mesh network with batman-adv

[Sven Eckelmann]

[-- Attachment #1: Type: text/plain, Size: 719 bytes --]

On Montag, 30. April 2018 23:18:59 CEST KwangMin Kim wrote:
[...]
> However, I have disabled one of these batman-adv settings and rejoined the wireless mesh network. 
> 
> As a result, only two raspberry pies that have set up batman-adv communicate.
> 
> is this right?

They still communicate in some sense with each other - just not on batman-adv 
and will thus not be able to reach services which run on top of batman-adv 
(for example some IPv4/v6 network).

> If so, how do I configure it so that non-batman-adv nodes and nodes with batman-adv enabled communicate with each other?

https://www.open-mesh.org/projects/batman-adv/wiki/Quick-start-guide#Mixing-non-BATMAN-systems-with-batman-adv


Kind regards,
	Sven

[-- Attachment #2: This is a digitally signed message part. --]
[-- Type: application/pgp-signature, Size: 833 bytes --]