[Buildroot] u-boot and at91bootstrap NAND flash options

[Buildroot] u-boot and at91bootstrap NAND flash options

[Matt Wood]

Hi guys, is there any specific reason why buildroot does not have options in the menuconfig to compile u-boot with NAND flash support for the AT91SAM9xxx devices?  I know that NAND support does not function for the RevA SAM9260, SAM9263, and the SAM9261, but Rev B has been out for a while for the first two and I think it would be nice to see the options in buildroot instead of having to build manually or download the pre-built binaries from www.linux4sam.org.  

Also, the NAND flash option for at91bootstrap does not work.  The NAND code is missing.  I know that at91bootstrap-1.9 (found here:  ftp://www.linux4sam.org/pub/at91bootstrap/) has fully functional NAND support - any reason why this has not been integrated into the buildroot at91bootstrap?

Thanks, Matt.
-- 
Sensationsangebot verl?ngert: GMX FreeDSL - Telefonanschluss + DSL 
f?r nur 16,37 Euro/mtl.!* http://dsl.gmx.de/?ac=OM.AD.PD003K1308T4569a

[Buildroot] u-boot and at91bootstrap NAND flash options

[Ulf Samuelsson]

> Hi guys, is there any specific reason why buildroot does not have options
> in the menuconfig to compile
> u-boot with NAND flash support for the AT91SAM9xxx devices?
> I know that NAND support does not function for the RevA SAM9260, SAM9263,
> and the SAM9261,
> but Rev B has been out for a while for the first two and I think it would
> be nice to see the
> options in buildroot instead of having to build manually or download the
> pre-built binaries from www.linux4sam.org.

> Also, the NAND flash option for at91bootstrap does not work.
> The NAND code is missing.
> I know that at91bootstrap-1.9 (found here:
> ftp://www.linux4sam.org/pub/at91bootstrap/) has fully functional NAND
> support
> - any reason why this has not been integrated into the buildroot
> at91bootstrap?

Same answer on both accounts.
Noone had the time to do it.

Atmels bootstrap needs porting work, to be able to run with buildroot.
It has a real strange way of "makeing" the target, and a tool
like buildroot needs deep internal knowledge about the internal
directory structure of at91bootstrap to be able to build the target.

I rewrote at91bootstrap, creating the v2.x series used by buildroot
where you use a Makefile in the top directory and a
make XXX_config command to configre the tool.

Have been testing, what I call 2.8 and 2.9 which uses KConfig to configure
at91bootstrap
and this is based on at91bootstrap-1.11 so most new things should  be there.

Have also been working on u-boot-2009.01-rc1 today and this
should allow more functionality.

I am not particularily interested in NAND flash, so that will receive  less
(no) testing,
but the basic source have little change so I do not see any big problems.



Best Regards
Ulf Samuelsson