[PATCH v5 4/4] media: imx-mipi-csis: Support active data lanes differing from maximum

[Isaac Scott <isaac.scott@ideasonboard.com>]

Call on v4l2_get_active_data_lanes() to check if the driver reports that
the number of lanes actively used by the MIPI CSI transmitter differs to
the maximum defined in device tree.

If the number of active data lanes reported by the driver is invalid, or
the operation is not supported, fall back to the number of allowed data
lanes.

Signed-off-by: Isaac Scott <isaac.scott@ideasonboard.com>
---
 drivers/media/platform/nxp/imx-mipi-csis.c | 4 ++++
 1 file changed, 4 insertions(+)

diff --git a/drivers/media/platform/nxp/imx-mipi-csis.c b/drivers/media/platform/nxp/imx-mipi-csis.c
index 838a1ad123b5..637ef6e614fa 100644
--- a/drivers/media/platform/nxp/imx-mipi-csis.c
+++ b/drivers/media/platform/nxp/imx-mipi-csis.c
@@ -1034,6 +1034,10 @@ static int mipi_csis_s_stream(struct v4l2_subdev *sd, int enable)
 	format = v4l2_subdev_state_get_format(state, CSIS_PAD_SINK);
 	csis_fmt = find_csis_format(format->code);
 
+	ret = v4l2_get_active_data_lanes(csis->source.pad,
+					 csis->bus.num_data_lanes);
+	csis->num_data_lanes = ret < 0 ? csis->bus.num_data_lanes : ret;
+
 	ret = mipi_csis_calculate_params(csis, csis_fmt);
 	if (ret < 0)
 		goto err_unlock;
-- 
2.43.0