From: Dave Gordon <david.s.gordon@intel.com>
To: intel-gfx@lists.freedesktop.org
Subject: [PATCH v4 1/3] drm/i915/guc: reset GuC and retry on firmware load failure
Date: Mon, 4 Apr 2016 18:50:56 +0100 [thread overview]
Message-ID: <1459792258-16645-2-git-send-email-david.s.gordon@intel.com> (raw)
In-Reply-To: <1459792258-16645-1-git-send-email-david.s.gordon@intel.com>
From: Arun Siluvery <arun.siluvery@linux.intel.com>
Due to timing issues in the HW, some of the status bits required for GuC
authentication occasionally don't get set; when that happens, the GuC
cannot be initialized and we will be left with a wedged GPU. The W/A
suggested is to perform a soft reset of the GuC and attempt to reload
the F/W again for few times before giving up.
As the failure is dependent on timing, tests performed by triggering
manual full gpu reset (i915_wedged) showed that we could sometimes hit
this after several thousand iterations, but sometimes tests ran even
longer without any issues. Reset and reload mechanism proved helpful
when we indeed hit f/w load failure, so it is better to include this
to improve driver stability.
This change implements the following WAs,
WaEnableuKernelHeaderValidFix:skl,bxt
WaEnableGuCBootHashCheckNotSet:skl,bxt
Signed-off-by: Arun Siluvery <arun.siluvery@linux.intel.com>
Signed-off-by: Dave Gordon <david.s.gordon@intel.com>
Reviewed-by: Alex Dai <yu.dai@intel.com>
---
drivers/gpu/drm/i915/i915_drv.h | 1 +
drivers/gpu/drm/i915/i915_guc_reg.h | 1 +
drivers/gpu/drm/i915/i915_reg.h | 1 +
drivers/gpu/drm/i915/intel_guc_loader.c | 49 +++++++++++++++++++++++++++++++--
drivers/gpu/drm/i915/intel_uncore.c | 19 +++++++++++++
5 files changed, 69 insertions(+), 2 deletions(-)
diff --git a/drivers/gpu/drm/i915/i915_drv.h b/drivers/gpu/drm/i915/i915_drv.h
index dd18772..1847ef9 100644
--- a/drivers/gpu/drm/i915/i915_drv.h
+++ b/drivers/gpu/drm/i915/i915_drv.h
@@ -2746,6 +2746,7 @@ extern long i915_compat_ioctl(struct file *filp, unsigned int cmd,
extern int intel_gpu_reset(struct drm_device *dev, u32 engine_mask);
extern bool intel_has_gpu_reset(struct drm_device *dev);
extern int i915_reset(struct drm_device *dev);
+extern int intel_guc_reset(struct drm_i915_private *dev_priv);
extern void intel_engine_init_hangcheck(struct intel_engine_cs *engine);
extern unsigned long i915_chipset_val(struct drm_i915_private *dev_priv);
extern unsigned long i915_mch_val(struct drm_i915_private *dev_priv);
diff --git a/drivers/gpu/drm/i915/i915_guc_reg.h b/drivers/gpu/drm/i915/i915_guc_reg.h
index e4ba582..94ceee5 100644
--- a/drivers/gpu/drm/i915/i915_guc_reg.h
+++ b/drivers/gpu/drm/i915/i915_guc_reg.h
@@ -27,6 +27,7 @@
/* Definitions of GuC H/W registers, bits, etc */
#define GUC_STATUS _MMIO(0xc000)
+#define GS_MIA_IN_RESET (1 << 0)
#define GS_BOOTROM_SHIFT 1
#define GS_BOOTROM_MASK (0x7F << GS_BOOTROM_SHIFT)
#define GS_BOOTROM_RSA_FAILED (0x50 << GS_BOOTROM_SHIFT)
diff --git a/drivers/gpu/drm/i915/i915_reg.h b/drivers/gpu/drm/i915/i915_reg.h
index 12f5103..f4ebf31 100644
--- a/drivers/gpu/drm/i915/i915_reg.h
+++ b/drivers/gpu/drm/i915/i915_reg.h
@@ -165,6 +165,7 @@ static inline bool i915_mmio_reg_valid(i915_reg_t reg)
#define GEN6_GRDOM_MEDIA (1 << 2)
#define GEN6_GRDOM_BLT (1 << 3)
#define GEN6_GRDOM_VECS (1 << 4)
+#define GEN9_GRDOM_GUC (1 << 5)
#define GEN8_GRDOM_MEDIA2 (1 << 7)
#define RING_PP_DIR_BASE(ring) _MMIO((ring)->mmio_base+0x228)
diff --git a/drivers/gpu/drm/i915/intel_guc_loader.c b/drivers/gpu/drm/i915/intel_guc_loader.c
index b4976f9..d84c560 100644
--- a/drivers/gpu/drm/i915/intel_guc_loader.c
+++ b/drivers/gpu/drm/i915/intel_guc_loader.c
@@ -353,6 +353,24 @@ static int guc_ucode_xfer(struct drm_i915_private *dev_priv)
return ret;
}
+static int i915_reset_guc(struct drm_i915_private *dev_priv)
+{
+ int ret;
+ u32 guc_status;
+
+ ret = intel_guc_reset(dev_priv);
+ if (ret) {
+ DRM_ERROR("GuC reset failed, ret = %d\n", ret);
+ return ret;
+ }
+
+ guc_status = I915_READ(GUC_STATUS);
+ WARN(!(guc_status & GS_MIA_IN_RESET),
+ "GuC status: 0x%x, MIA core expected to be in reset\n", guc_status);
+
+ return ret;
+}
+
/**
* intel_guc_ucode_load() - load GuC uCode into the device
* @dev: drm device
@@ -417,9 +435,36 @@ int intel_guc_ucode_load(struct drm_device *dev)
if (err)
goto fail;
+ /*
+ * WaEnableuKernelHeaderValidFix:skl,bxt
+ * For BXT, this is only upto B0 but below WA is required for later
+ * steppings also so this is extended as well.
+ */
+ /* WaEnableGuCBootHashCheckNotSet:skl,bxt */
err = guc_ucode_xfer(dev_priv);
- if (err)
- goto fail;
+ if (err) {
+ int retries = 3;
+
+ DRM_ERROR("GuC fw load failed, err=%d, attempting reset and retry\n", err);
+
+ while (retries--) {
+ err = i915_reset_guc(dev_priv);
+ if (err)
+ break;
+
+ err = guc_ucode_xfer(dev_priv);
+ if (!err) {
+ DRM_DEBUG_DRIVER("GuC fw reload succeeded after reset\n");
+ break;
+ }
+ DRM_DEBUG_DRIVER("GuC fw reload retries left: %d\n", retries);
+ }
+
+ if (err) {
+ DRM_ERROR("GuC fw reload attempt failed, ret=%d\n", err);
+ goto fail;
+ }
+ }
guc_fw->guc_fw_load_status = GUC_FIRMWARE_SUCCESS;
diff --git a/drivers/gpu/drm/i915/intel_uncore.c b/drivers/gpu/drm/i915/intel_uncore.c
index ac1c545..fbc1d21 100644
--- a/drivers/gpu/drm/i915/intel_uncore.c
+++ b/drivers/gpu/drm/i915/intel_uncore.c
@@ -1673,6 +1673,25 @@ bool intel_has_gpu_reset(struct drm_device *dev)
return intel_get_gpu_reset(dev) != NULL;
}
+int intel_guc_reset(struct drm_i915_private *dev_priv)
+{
+ int ret;
+ unsigned long irqflags;
+
+ if (!i915.enable_guc_submission)
+ return -EINVAL;
+
+ intel_uncore_forcewake_get(dev_priv, FORCEWAKE_ALL);
+ spin_lock_irqsave(&dev_priv->uncore.lock, irqflags);
+
+ ret = gen6_hw_domain_reset(dev_priv, GEN9_GRDOM_GUC);
+
+ spin_unlock_irqrestore(&dev_priv->uncore.lock, irqflags);
+ intel_uncore_forcewake_put(dev_priv, FORCEWAKE_ALL);
+
+ return ret;
+}
+
bool intel_uncore_unclaimed_mmio(struct drm_i915_private *dev_priv)
{
return check_for_unclaimed_mmio(dev_priv);
--
1.9.1
_______________________________________________
Intel-gfx mailing list
Intel-gfx@lists.freedesktop.org
https://lists.freedesktop.org/mailman/listinfo/intel-gfx
next prev parent reply other threads:[~2016-04-04 17:51 UTC|newest]
Thread overview: 7+ messages / expand[flat|nested] mbox.gz Atom feed top
2016-04-04 17:50 [PATCH v4 0/3] GuC reset-and-retry patches (resend) Dave Gordon
2016-04-04 17:50 ` Dave Gordon [this message]
2016-04-04 17:50 ` [PATCH v4 2/3] drm/i915/guc: always reset GuC before loading firmware Dave Gordon
2016-04-04 17:50 ` [PATCH v4 3/3] DO NOT MERGE: add enable_guc_loading parameter Dave Gordon
2016-04-05 6:56 ` ✗ Fi.CI.BAT: failure for GuC reset-and-retry patches (resend) Patchwork
2016-04-05 12:03 ` Dave Gordon
2016-04-05 12:32 ` Tvrtko Ursulin
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=1459792258-16645-2-git-send-email-david.s.gordon@intel.com \
--to=david.s.gordon@intel.com \
--cc=intel-gfx@lists.freedesktop.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox