[PATCH v9 4/7] drm/i915/tgl: Do modeset to enable and configure DC3CO exitline

[Anshuman Gupta <anshuman.gupta@intel.com>]

DC3CO enabling B.Specs sequence requires to enable end configure
exit scanlines to TRANS_EXITLINE register, programming this register
has to be part of modeset sequence as this can't be change when
transcoder or port is enabled.
When system boots with only eDP panel there may not be real
modeset as BIOS has already programmed the necessary registers,
therefore it needs to force a modeset to enable and configure
DC3CO exitline.

v1: Computing dc3co_exitline crtc state from a DP encoder
    compute config. [Imre]
    Enabling and disabling DC3CO PSR2 transcoder exitline from
    encoder pre_enable and post_disable hooks. [Imre]
    Computing dc3co_exitline instead of has_dc3co_exitline bool. [Imre]

Cc: Jani Nikula <jani.nikula@intel.com>
Cc: Imre Deak <imre.deak@intel.com>
Cc: Animesh Manna <animesh.manna@intel.com>
Signed-off-by: Anshuman Gupta <anshuman.gupta@intel.com>
---
 drivers/gpu/drm/i915/display/intel_ddi.c      |   7 ++
 drivers/gpu/drm/i915/display/intel_display.c  |   1 +
 .../drm/i915/display/intel_display_power.c    | 100 ++++++++++++++++++
 .../drm/i915/display/intel_display_power.h    |   7 ++
 .../drm/i915/display/intel_display_types.h    |   1 +
 drivers/gpu/drm/i915/display/intel_dp.c       |   2 +
 6 files changed, 118 insertions(+)

diff --git a/drivers/gpu/drm/i915/display/intel_ddi.c b/drivers/gpu/drm/i915/display/intel_ddi.c
index 3e6394139964..87669e516cc9 100644
--- a/drivers/gpu/drm/i915/display/intel_ddi.c
+++ b/drivers/gpu/drm/i915/display/intel_ddi.c
@@ -3212,6 +3212,8 @@ static void tgl_ddi_pre_enable_dp(struct intel_encoder *encoder,
 	int level = intel_ddi_dp_level(intel_dp);
 	enum transcoder transcoder = crtc_state->cpu_transcoder;
 
+	/* Program the dc3co psr2 transcoder exitline */
+	tgl_set_psr2_transcoder_exitline(crtc_state);
 	intel_dp_set_link_params(intel_dp, crtc_state->port_clock,
 				 crtc_state->lane_count, is_mst);
 
@@ -3521,6 +3523,8 @@ static void intel_ddi_post_disable_dp(struct intel_encoder *encoder,
 						  dig_port->ddi_io_power_domain);
 
 	intel_ddi_clk_disable(encoder);
+	/* Disable the dc3co psr2 transcoder exitline */
+	tgl_clear_psr2_transcoder_exitline(old_crtc_state);
 }
 
 static void intel_ddi_post_disable_hdmi(struct intel_encoder *encoder,
@@ -4050,6 +4054,9 @@ void intel_ddi_get_config(struct intel_encoder *encoder,
 		break;
 	}
 
+	if (encoder->type == INTEL_OUTPUT_EDP)
+		tgl_dc3co_exitline_get_config(pipe_config);
+
 	pipe_config->has_audio =
 		intel_ddi_is_audio_enabled(dev_priv, cpu_transcoder);
 
diff --git a/drivers/gpu/drm/i915/display/intel_display.c b/drivers/gpu/drm/i915/display/intel_display.c
index a19f8c73f2e0..38efdd392556 100644
--- a/drivers/gpu/drm/i915/display/intel_display.c
+++ b/drivers/gpu/drm/i915/display/intel_display.c
@@ -12739,6 +12739,7 @@ intel_pipe_config_compare(const struct intel_crtc_state *current_config,
 
 	PIPE_CONF_CHECK_I(pixel_multiplier);
 	PIPE_CONF_CHECK_I(output_format);
+	PIPE_CONF_CHECK_I(dc3co_exitline);
 	PIPE_CONF_CHECK_BOOL(has_hdmi_sink);
 	if ((INTEL_GEN(dev_priv) < 8 && !IS_HASWELL(dev_priv)) ||
 	    IS_VALLEYVIEW(dev_priv) || IS_CHERRYVIEW(dev_priv))
diff --git a/drivers/gpu/drm/i915/display/intel_display_power.c b/drivers/gpu/drm/i915/display/intel_display_power.c
index c4a6c7638d92..3fcee8f3ae67 100644
--- a/drivers/gpu/drm/i915/display/intel_display_power.c
+++ b/drivers/gpu/drm/i915/display/intel_display_power.c
@@ -19,6 +19,7 @@
 #include "intel_hotplug.h"
 #include "intel_sideband.h"
 #include "intel_tc.h"
+#include "intel_pm.h"
 
 bool intel_display_power_well_is_enabled(struct drm_i915_private *dev_priv,
 					 enum i915_power_well_id power_well_id);
@@ -772,6 +773,105 @@ static void gen9_set_dc_state(struct drm_i915_private *dev_priv, u32 state)
 	dev_priv->csr.dc_state = val & mask;
 }
 
+int intel_get_scan_linetime_us(const struct drm_display_mode *adjusted_mode)
+{
+	/* paranoia */
+	if (WARN_ON(!adjusted_mode->crtc_clock))
+		return 0;
+
+	return DIV_ROUND_UP(1000 * adjusted_mode->crtc_htotal,
+			    adjusted_mode->crtc_clock);
+}
+
+void tgl_clear_psr2_transcoder_exitline(const struct intel_crtc_state *cstate)
+{
+	struct drm_i915_private *dev_priv = to_i915(cstate->base.crtc->dev);
+	u32 val;
+
+	if (!cstate->dc3co_exitline)
+		return;
+
+	val = I915_READ(EXITLINE(cstate->cpu_transcoder));
+	val &= ~(EXITLINE_MASK | EXITLINE_ENABLE);
+	I915_WRITE(EXITLINE(cstate->cpu_transcoder), val);
+}
+
+void tgl_set_psr2_transcoder_exitline(const struct intel_crtc_state *cstate)
+{
+	u32 val, exit_scanlines;
+	struct drm_i915_private *dev_priv = to_i915(cstate->base.crtc->dev);
+
+	if (!cstate->dc3co_exitline)
+		return;
+
+	exit_scanlines = cstate->dc3co_exitline;
+	exit_scanlines <<= EXITLINE_SHIFT;
+	val = I915_READ(EXITLINE(cstate->cpu_transcoder));
+	val &= ~(EXITLINE_MASK | EXITLINE_ENABLE);
+	val |= exit_scanlines;
+	val |= EXITLINE_ENABLE;
+	I915_WRITE(EXITLINE(cstate->cpu_transcoder), val);
+}
+
+/*
+ * DC3CO requires to enable exitline and program DC3CO requires
+ * exit scanlines to TRANS_EXITLINE register, which should only
+ * change before transcoder or port are enabled.
+ * This requires to disable the fastset at boot for eDP output.
+ */
+void tgl_dc3co_exitline_compute_config(struct intel_encoder *encoder,
+				       struct intel_crtc_state *crtc_state)
+{
+	u32 linetime_us, exit_scanlines;
+	struct drm_i915_private *dev_priv = to_i915(crtc_state->base.crtc->dev);
+	u32 crtc_vdisplay = crtc_state->base.adjusted_mode.crtc_vdisplay;
+
+	if (!IS_TIGERLAKE(dev_priv))
+		return;
+
+	if (!(dev_priv->csr.allowed_dc_mask & DC_STATE_EN_DC3CO))
+		return;
+
+	/* B.Specs:49196 DC3CO only works with pipeA and DDIA.*/
+	if (encoder->port != PORT_A)
+		return;
+
+	if (!crtc_state->has_psr2 || !crtc_state->base.active)
+		return;
+
+	linetime_us =
+		intel_get_scan_linetime_us(&crtc_state->base.adjusted_mode);
+
+	if (WARN_ON(!linetime_us))
+		return;
+	/*
+	 * DC3CO Exit time 200us B.Spec 49196
+	 * PSR2 transcoder Early Exit scanlines = ROUNDUP(200 / line time) + 1
+	 */
+	exit_scanlines = DIV_ROUND_UP(200, linetime_us) + 1;
+	if (WARN_ON(exit_scanlines > crtc_vdisplay))
+		return;
+
+	crtc_state->dc3co_exitline = crtc_vdisplay - exit_scanlines;
+}
+
+void tgl_dc3co_exitline_get_config(struct intel_crtc_state *crtc_state)
+{
+	u32 val;
+	struct drm_i915_private *dev_priv = to_i915(crtc_state->base.crtc->dev);
+
+	if (!IS_TIGERLAKE(dev_priv))
+		return;
+
+	if (!(dev_priv->csr.allowed_dc_mask & DC_STATE_EN_DC3CO))
+		return;
+
+	val = I915_READ(EXITLINE(crtc_state->cpu_transcoder));
+
+	if (val & EXITLINE_ENABLE)
+		crtc_state->dc3co_exitline = val & EXITLINE_MASK;
+}
+
 static void
 allowed_dc_mask_to_target_dc_state(struct drm_i915_private *dev_priv)
 {
diff --git a/drivers/gpu/drm/i915/display/intel_display_power.h b/drivers/gpu/drm/i915/display/intel_display_power.h
index 13fc705799fd..981b6a52d192 100644
--- a/drivers/gpu/drm/i915/display/intel_display_power.h
+++ b/drivers/gpu/drm/i915/display/intel_display_power.h
@@ -12,6 +12,8 @@
 
 struct drm_i915_private;
 struct intel_encoder;
+struct intel_crtc_state;
+struct intel_atomic_state;
 
 enum intel_display_power_domain {
 	POWER_DOMAIN_DISPLAY_CORE,
@@ -258,6 +260,11 @@ void intel_display_power_resume_early(struct drm_i915_private *i915);
 void intel_display_power_suspend(struct drm_i915_private *i915);
 void intel_display_power_resume(struct drm_i915_private *i915);
 void tgl_set_target_dc_state(struct drm_i915_private *dev_priv, u32 state);
+void tgl_dc3co_exitline_compute_config(struct intel_encoder *encoder,
+				       struct intel_crtc_state *crtc_state);
+void tgl_dc3co_exitline_get_config(struct intel_crtc_state *crtc_state);
+void tgl_clear_psr2_transcoder_exitline(const struct intel_crtc_state *state);
+void tgl_set_psr2_transcoder_exitline(const struct intel_crtc_state *state);
 
 const char *
 intel_display_power_domain_str(enum intel_display_power_domain domain);
diff --git a/drivers/gpu/drm/i915/display/intel_display_types.h b/drivers/gpu/drm/i915/display/intel_display_types.h
index d5cc4b810d9e..46573fb5a152 100644
--- a/drivers/gpu/drm/i915/display/intel_display_types.h
+++ b/drivers/gpu/drm/i915/display/intel_display_types.h
@@ -871,6 +871,7 @@ struct intel_crtc_state {
 
 	bool has_psr;
 	bool has_psr2;
+	u32 dc3co_exitline;
 
 	/*
 	 * Frequence the dpll for the port should run at. Differs from the
diff --git a/drivers/gpu/drm/i915/display/intel_dp.c b/drivers/gpu/drm/i915/display/intel_dp.c
index d09133a958e1..68bfaf13daf1 100644
--- a/drivers/gpu/drm/i915/display/intel_dp.c
+++ b/drivers/gpu/drm/i915/display/intel_dp.c
@@ -2267,6 +2267,8 @@ intel_dp_compute_config(struct intel_encoder *encoder,
 
 	intel_psr_compute_config(intel_dp, pipe_config);
 
+	tgl_dc3co_exitline_compute_config(encoder, pipe_config);
+
 	intel_hdcp_transcoder_config(intel_connector,
 				     pipe_config->cpu_transcoder);
 
-- 
2.21.0

_______________________________________________
Intel-gfx mailing list
Intel-gfx@lists.freedesktop.org
https://lists.freedesktop.org/mailman/listinfo/intel-gfx