From: Neftin, Sasha <sasha.neftin@intel.com>
To: intel-wired-lan@osuosl.org
Subject: [Intel-wired-lan] [PATCH v1 1/1] igc: Fix BUG: scheduling while atomic: kworker/u64:0/9/0x00000002
Date: Tue, 8 Mar 2022 19:34:48 +0200 [thread overview]
Message-ID: <4485d49c-7051-97d2-d5a7-0729e68ce7a7@intel.com> (raw)
In-Reply-To: <Yid7HCwekP1IsMN3@calimero.vinschen.de>
On 3/8/2022 17:49, Corinna Vinschen wrote:
> Hi Sasha,
>
> On Mar 8 11:24, Sasha Neftin wrote:
>> Replace usleep_range() method with udelay() method to allow atomic contects
>> in low-level MDIO access functions.
>
> The commit message is a bit on the short end. It should probably quote
> the reproducer from the below Bugzilla, rather than just pointing to the
> Bugzilla, i.e.,
Thanks Corinna and Maciej - I will resend v2.
>
> $ modprobe -r bonding
> $ modprobe -v bonding max_bonds=1 mode=1 miimon=100 use_carrier=0
> $ ip link set bond0 up
> $ ifenslave bond0 eth0 eth1
>
> leads to the following [shortened] kernel log:
>
> [ 120.198086] Voluntary context switch within RCU read-side critical section!
> [ 120.198093] WARNING: CPU: 3 PID: 10 at kernel/rcu/tree_plugin.h:318 rcu_note_context_switch+0x4ea/0x580
> [ 120.207310] bond0: (slave ens5f0): Enslaving as a backup interface with a down link
> [ 120.229488] [...]
> [ 120.754723] Workqueue: bond0 bond_mii_monitor [bonding]
> [ 120.779106] RIP: 0010:rcu_note_context_switch+0x4ea/0x580
> [ 120.803880] Code: 08 49 89 8e 40 08 00 00 4d 89 be 48 08 00 00 4d 89 07 e9 98 fe ff ff 48 c7 c7 48 83 94 b6 c6 05 74 3b e1 01 01 e8 35 fd 8a 00 <0f> 0b e9 67 fb ff ff 45 85 f6 0f 84 9e fe ff ff 4c 89 85 a8 00 00
> [ 120.890778] RSP: 0018:ffffa2f5c01bbbc8 EFLAGS: 00010082
> [ 120.915218] RAX: 0000000000000000 RBX: ffff938d6f8f1740 RCX: 0000000000000027
> [ 120.948713] RDX: 0000000000000027 RSI: ffff938d6f8dfcc0 RDI: ffff938d6f8dfcc8
> [ 120.982368] RBP: ffffa2f5c01bbc50 R08: 0000000000000000 R09: c0000000ffff7fff
> [ 121.016065] R10: 0000000000000001 R11: ffffa2f5c01bb9e0 R12: ffff938a022a9980
> [ 121.049504] R13: 0000000000000000 R14: 0000000000000000 R15: 0000000000000001
> [ 121.082870] FS: 0000000000000000(0000) GS:ffff938d6f8c0000(0000) knlGS:0000000000000000
> [ 121.121993] CS: 0010 DS: 0000 ES: 0000 CR0: 0000000080050033
> [ 121.151532] CR2: 0000556901ea4f28 CR3: 0000000482810001 CR4: 00000000001706e0
> [ 121.186337] Call Trace:
> [ 121.197543] <TASK>
> [ 121.207444] __schedule+0x9a/0x7b0
> [ 121.223316] ? hrtimer_start_range_ns+0x11d/0x300
> [ 121.245293] schedule+0x41/0xc0
> [ 121.259860] schedule_hrtimeout_range_clock+0x83/0x100
> [ 121.283548] ? hrtimer_init_sleeper+0x80/0x80
> [ 121.303830] usleep_range_state+0x5b/0x80
> [ 121.322747] igc_read_phy_reg_gpy+0x90/0x180 [igc]
> [ 121.345249] igc_phy_has_link+0x7d/0x170 [igc]
> [ 121.365980] igc_check_for_copper_link+0x60/0xd0 [igc]
> [ 121.390260] igc_has_link+0x2a/0x80 [igc]
> [ 121.409093] igc_ethtool_get_link+0x24/0x30 [igc]
> [ 121.431248] bond_check_dev_link.isra.49+0x5a/0x120 [bonding]
> [ 121.458271] ? pick_next_task_fair+0x3e/0x3b0
> [ 121.478749] ? put_prev_entity+0x22/0xe0
> [ 121.497154] ? put_prev_task_fair+0x1b/0x30
> [ 121.516903] bond_mii_monitor+0x107/0x540 [bonding]
> [...]
>
>> Fixes: 5586838fe9ce ("igc: Add code for PHY support")
>> Reported-by: Corinna Vinschen <vinschen@redhat.com>
>> Suggested-by: Dima Ruinskiy <dima.ruinskiy@intel.com>
>> Signed-off-by: Sasha Neftin <sasha.neftin@intel.com>
>> ---
>> drivers/net/ethernet/intel/igc/igc_phy.c | 4 ++--
>> 1 file changed, 2 insertions(+), 2 deletions(-)
>>
>> diff --git a/drivers/net/ethernet/intel/igc/igc_phy.c b/drivers/net/ethernet/intel/igc/igc_phy.c
>> index 40dbf4b43234..6961f65d36b9 100644
>> --- a/drivers/net/ethernet/intel/igc/igc_phy.c
>> +++ b/drivers/net/ethernet/intel/igc/igc_phy.c
>> @@ -581,7 +581,7 @@ static s32 igc_read_phy_reg_mdic(struct igc_hw *hw, u32 offset, u16 *data)
>> * the lower time out
>> */
>> for (i = 0; i < IGC_GEN_POLL_TIMEOUT; i++) {
>> - usleep_range(500, 1000);
>> + udelay(50);
>> mdic = rd32(IGC_MDIC);
>> if (mdic & IGC_MDIC_READY)
>> break;
>> @@ -638,7 +638,7 @@ static s32 igc_write_phy_reg_mdic(struct igc_hw *hw, u32 offset, u16 data)
>> * the lower time out
>> */
>> for (i = 0; i < IGC_GEN_POLL_TIMEOUT; i++) {
>> - usleep_range(500, 1000);
>> + udelay(50);
>> mdic = rd32(IGC_MDIC);
>> if (mdic & IGC_MDIC_READY)
>> break;
>> --
>> 2.30.2
>
> Tested-by: Corinna Vinschen <vinschen@redhat.com>
>
>
> Thanks,
> Corinna
>
next prev parent reply other threads:[~2022-03-08 17:34 UTC|newest]
Thread overview: 5+ messages / expand[flat|nested] mbox.gz Atom feed top
2022-03-08 9:24 [Intel-wired-lan] [PATCH v1 1/1] igc: Fix BUG: scheduling while atomic: kworker/u64:0/9/0x00000002 Sasha Neftin
2022-03-08 9:31 ` Maciej Fijalkowski
2022-03-08 15:49 ` Corinna Vinschen
2022-03-08 17:34 ` Neftin, Sasha [this message]
2022-03-24 10:23 ` naamax.meir
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=4485d49c-7051-97d2-d5a7-0729e68ce7a7@intel.com \
--to=sasha.neftin@intel.com \
--cc=intel-wired-lan@osuosl.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox