From: Philip Stewart <philip.stewart.public@gmail.com>
To: iwd@lists.01.org
Subject: DEL_INTERFACE and CMD_SET_CQM failed; Could not register frame watch type 00d0: -95
Date: Sun, 18 Apr 2021 18:21:47 +0100 [thread overview]
Message-ID: <B8SRRQ.IJ5TG5C88S3O3@gmail.com> (raw)
[-- Attachment #1: Type: text/plain, Size: 4493 bytes --]
Hello,
I've recently switched from NetworkManager and wpasupplicant to
systemd-networkd and iwd. Whilst everything appears to be working fine,
I'm curious about some failures reported by iwd:
Apr 18 15:10:32 systemd[1]: Starting Wireless service...
Apr 18 15:10:33 iwd[661]: Wireless daemon version 1.12
Apr 18 15:10:33 systemd[1]: Started Wireless service.
Apr 18 15:10:33 iwd[661]: station: Network configuration is disabled.
Apr 18 15:10:33 iwd[661]: Wiphy: 0, Name: phy0
Apr 18 15:10:33 iwd[661]: Permanent Address: 00:00:00:00:00:00
Apr 18 15:10:33 iwd[661]: Bands: 2.4 GHz 5 GHz
Apr 18 15:10:33 iwd[661]: Ciphers: CCMP TKIP BIP
Apr 18 15:10:33 iwd[661]: Supported iftypes: ad-hoc station
Apr 18 15:10:33 iwd[661]: DEL_INTERFACE failed: Operation not supported
Apr 18 15:10:33 iwd[661]: Could not register frame watch type 00d0: -95
Apr 18 15:10:33 iwd[661]: Could not register frame watch type 00d0: -95
Apr 18 15:10:33 iwd[661]: Could not register frame watch type 00d0: -95
Apr 18 15:10:33 iwd[661]: Could not register frame watch type 00d0: -95
Apr 18 15:10:33 iwd[661]: CMD_SET_CQM failed: Operation not supported
Apr 18 15:10:33 iwd[661]: Could not register frame watch type 00d0: -95
Apr 18 15:10:33 iwd[661]: Could not register frame watch type 00d0: -95
Further, I note that in the output of 'networkctl status wlan0', the
WiFi access point MAC address is reported as 00:00:00:00:00:00 and I'm
wondering if this is a consequence of these failures and if there is
anything I can do about it?
Kind regards,
Phil
# lspci -vv -d 14e4:
03:00.0 Network controller: Broadcom Inc. and subsidiaries BCM4322
802.11a/b/g/n Wireless LAN Controller (rev 01)
Subsystem: Apple Inc. AirPort Extreme
Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr-
Stepping- SERR- FastB2B- DisINTx-
Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=fast >TAbort-
<TAbort- <MAbort- >SERR- <PERR- INTx-
Latency: 0, Cache Line Size: 256 bytes
Interrupt: pin A routed to IRQ 20
Region 0: Memory@d3200000 (64-bit, non-prefetchable) [size=16K]
Capabilities: [40] Power Management version 3
Flags: PMEClk- DSI- D1+ D2+ AuxCurrent=0mA
PME(D0+,D1-,D2-,D3hot+,D3cold+)
Status: D0 NoSoftRst+ PME-Enable- DSel=0 DScale=2 PME-
Capabilities: [58] Vendor Specific Information: Len=78 <?>
Capabilities: [e8] MSI: Enable- Count=1/1 Maskable- 64bit+
Address: 0000000000000000 Data: 0000
Capabilities: [d0] Express (v1) Endpoint, MSI 00
DevCap: MaxPayload 128 bytes, PhantFunc 0, Latency L0s <4us, L1
unlimited
ExtTag+ AttnBtn- AttnInd- PwrInd- RBE+ FLReset- SlotPowerLimit 0.000W
DevCtl: CorrErr- NonFatalErr- FatalErr- UnsupReq-
RlxdOrd- ExtTag+ PhantFunc- AuxPwr- NoSnoop-
MaxPayload 128 bytes, MaxReadReq 128 bytes
DevSta: CorrErr- NonFatalErr- FatalErr- UnsupReq- AuxPwr- TransPend-
LnkCap: Port #0, Speed 2.5GT/s, Width x1, ASPM L0s L1, Exit Latency
L0s <4us, L1 <64us
ClockPM+ Surprise- LLActRep- BwNot- ASPMOptComp-
LnkCtl: ASPM L0s L1 Enabled; RCB 64 bytes, Disabled- CommClk+
ExtSynch- ClockPM+ AutWidDis- BWInt- AutBWInt-
LnkSta: Speed 2.5GT/s (ok), Width x1 (ok)
TrErr- Train- SlotClk+ DLActive- BWMgmt- ABWMgmt-
Capabilities: [100 v1] Advanced Error Reporting
UESta: DLP- SDES- TLP- FCP- CmpltTO- CmpltAbrt- UnxCmplt- RxOF-
MalfTLP- ECRC- UnsupReq- ACSViol-
UEMsk: DLP- SDES- TLP- FCP- CmpltTO- CmpltAbrt- UnxCmplt- RxOF-
MalfTLP- ECRC- UnsupReq- ACSViol-
UESvrt: DLP+ SDES- TLP- FCP+ CmpltTO- CmpltAbrt- UnxCmplt- RxOF+
MalfTLP+ ECRC- UnsupReq- ACSViol-
CESta: RxErr- BadTLP- BadDLLP- Rollover- Timeout- AdvNonFatalErr-
CEMsk: RxErr- BadTLP- BadDLLP- Rollover- Timeout- AdvNonFatalErr+
AERCap: First Error Pointer: 00, ECRCGenCap+ ECRCGenEn- ECRCChkCap+
ECRCChkEn-
MultHdrRecCap- MultHdrRecEn- TLPPfxPres- HdrLogCap-
HeaderLog: 00000000 00000000 00000000 00000000
Capabilities: [13c v1] Virtual Channel
Caps: LPEVC=0 RefClk=100ns PATEntryBits=1
Arb: Fixed- WRR32- WRR64- WRR128-
Ctrl: ArbSelect=Fixed
Status: InProgress-
VC0: Caps: PATOffset=00 MaxTimeSlots=1 RejSnoopTrans-
Arb: Fixed- WRR32- WRR64- WRR128- TWRR128- WRR256-
Ctrl: Enable+ ID=0 ArbSelect=Fixed TC/VC=ff
Status: NegoPending- InProgress-
Capabilities: [160 v1] Device Serial Number xx-xx-xx-xx-xx-xx-xx-xx
Capabilities: [16c v1] Power Budgeting <?>
Kernel driver in use: wl
Kernel modules: ssb, wl
next reply other threads:[~2021-04-18 17:21 UTC|newest]
Thread overview: 9+ messages / expand[flat|nested] mbox.gz Atom feed top
2021-04-18 17:21 Philip Stewart [this message]
2021-04-19 16:07 ` DEL_INTERFACE and CMD_SET_CQM failed; Could not register frame watch type 00d0: -95 James Prestwood
2021-04-19 18:16 ` Philip Stewart
2021-04-19 19:06 ` James Prestwood
2021-04-19 19:58 ` Philip Stewart
2021-04-19 20:10 ` James Prestwood
2021-04-19 20:41 ` Philip Stewart
2021-04-19 20:55 ` Denis Kenzior
2021-04-19 21:25 ` Philip Stewart
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=B8SRRQ.IJ5TG5C88S3O3@gmail.com \
--to=philip.stewart.public@gmail.com \
--cc=iwd@lists.01.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox