Re: [RFC PATCH 1/6] kvm: add device control API

[Gleb Natapov <gleb@redhat.com>]

Copying Christoffer since ARM has in kernel irq chip too.

On Wed, Feb 13, 2013 at 11:49:15PM -0600, Scott Wood wrote:
> Currently, devices that are emulated inside KVM are configured in a
> hardcoded manner based on an assumption that any given architecture
> only has one way to do it.  If there's any need to access device state,
> it is done through inflexible one-purpose-only IOCTLs (e.g.
> KVM_GET/SET_LAPIC).  Defining new IOCTLs for every little thing is
> cumbersome and depletes a limited numberspace.
> 
> This API provides a mechanism to instantiate a device of a certain
> type, returning an ID that can be used to set/get attributes of the
> device.  Attributes may include configuration parameters (e.g.
> register base address), device state, operational commands, etc.  It
> is similar to the ONE_REG API, except that it acts on devices rather
> than vcpus.
You are not only provide different way to create in kernel irq chip you
also use an alternate way to trigger interrupt lines. Before going into
interface specifics lets think about whether it is really worth it? x86
obviously support old way and will have to for some, very long, time.
ARM vGIC code, that is ready to go upstream, uses old way too. So it will
be 2 archs against one. Christoffer do you think the proposed way it
better for your needs. Are you willing to make vGIC use it?

Scott, what other devices are you planning to support with this
interface?

--
			Gleb.