[PATCH v6 11/11] arm64: Document Arm Confidential Compute

[Steven Price <steven.price@arm.com>]

Add some documentation on Arm CCA and the requirements for running Linux
as a Realm guest. Also update booting.rst to describe the requirement
for RIPAS RAM.

Signed-off-by: Steven Price <steven.price@arm.com>
---
 Documentation/arch/arm64/arm-cca.rst | 67 ++++++++++++++++++++++++++++
 Documentation/arch/arm64/booting.rst |  3 ++
 Documentation/arch/arm64/index.rst   |  1 +
 3 files changed, 71 insertions(+)
 create mode 100644 Documentation/arch/arm64/arm-cca.rst

diff --git a/Documentation/arch/arm64/arm-cca.rst b/Documentation/arch/arm64/arm-cca.rst
new file mode 100644
index 000000000000..ab7f90e64c2f
--- /dev/null
+++ b/Documentation/arch/arm64/arm-cca.rst
@@ -0,0 +1,67 @@
+.. SPDX-License-Identifier: GPL-2.0
+
+=====================================
+Arm Confidential Compute Architecture
+=====================================
+
+Arm systems that support the Realm Management Extension (RME) contain
+hardware to allow a VM guest to be run in a way which protects the code
+and data of the guest from the hypervisor. It extends the older "two
+world" model (Normal and Secure World) into four worlds: Normal, Secure,
+Root and Realm. Linux can then also be run as a guest to a monitor
+running in the Realm world.
+
+The monitor running in the Realm world is known as the Realm Management
+Monitor (RMM) and implements the Realm Management Monitor
+specification[1]. The monitor acts a bit like a hypervisor (e.g. it runs
+in EL2 and manages the stage 2 page tables etc of the guests running in
+Realm world), however much of the control is handled by a hypervisor
+running in the Normal World. The Normal World hypervisor uses the Realm
+Management Interface (RMI) defined by the RMM specification to request
+the RMM to perform operations (e.g. mapping memory or executing a vCPU).
+
+The RMM defines an environment for guests where the address space (IPA)
+is split into two. The lower half is protected - any memory that is
+mapped in this half cannot be seen by the Normal World and the RMM
+restricts what operations the Normal World can perform on this memory
+(e.g. the Normal World cannot replace pages in this region without the
+guest's cooperation). The upper half is shared, the Normal World is free
+to make changes to the pages in this region, and is able to emulate MMIO
+devices in this region too.
+
+A guest running in a Realm may also communicate with the RMM to request
+changes in its environment or to perform attestation about its
+environment. In particular it may request that areas of the protected
+address space are transitioned between 'RAM' and 'EMPTY' (in either
+direction). This allows a Realm guest to give up memory to be returned
+to the Normal World, or to request new memory from the Normal World.
+Without an explicit request from the Realm guest the RMM will otherwise
+prevent the Normal World from making these changes.
+
+Linux as a Realm Guest
+----------------------
+
+To run Linux as a guest within a Realm, the following must be provided
+either by the VMM or by a `boot loader` run in the Realm before Linux:
+
+ * All protected RAM described to Linux (by DT or ACPI) must be marked
+   RIPAS RAM before handing over the Linux.
+
+ * MMIO devices must be either unprotected (e.g. emulated by the Normal
+   World) or marked RIPAS DEV.
+
+ * MMIO devices emulated by the Normal World and used very early in boot
+   (specifically earlycon) must be specified in the upper half of IPA.
+   For earlycon this can be done by specifying the address on the
+   command line, e.g.: ``earlycon=uart,mmio,0x101000000``
+
+ * Linux will use bounce buffers for communicating with unprotected
+   devices. It will transition some protected memory to RIPAS EMPTY and
+   expect to be able to access unprotected pages at the same IPA address
+   but with the highest valid IPA bit set. The expectation is that the
+   VMM will remove the physical pages from the protected mapping and
+   provide those pages as unprotected pages.
+
+References
+----------
+[1] https://developer.arm.com/documentation/den0137/
diff --git a/Documentation/arch/arm64/booting.rst b/Documentation/arch/arm64/booting.rst
index b57776a68f15..30164fb24a24 100644
--- a/Documentation/arch/arm64/booting.rst
+++ b/Documentation/arch/arm64/booting.rst
@@ -41,6 +41,9 @@ to automatically locate and size all RAM, or it may use knowledge of
 the RAM in the machine, or any other method the boot loader designer
 sees fit.)
 
+For Arm Confidential Compute Realms this includes ensuring that all
+protected RAM has a Realm IPA state (RIPAS) of "RAM".
+
 
 2. Setup the device tree
 -------------------------
diff --git a/Documentation/arch/arm64/index.rst b/Documentation/arch/arm64/index.rst
index 78544de0a8a9..12c243c3af20 100644
--- a/Documentation/arch/arm64/index.rst
+++ b/Documentation/arch/arm64/index.rst
@@ -10,6 +10,7 @@ ARM64 Architecture
     acpi_object_usage
     amu
     arm-acpi
+    arm-cca
     asymmetric-32bit
     booting
     cpu-feature-registers
-- 
2.34.1