From: Will Deacon <will@kernel.org>
To: kvmarm@lists.cs.columbia.edu
Cc: kernel-team@android.com, Marc Zyngier <maz@kernel.org>,
Catalin Marinas <catalin.marinas@arm.com>,
Will Deacon <will@kernel.org>,
linux-arm-kernel@lists.infradead.org
Subject: [PATCH v3 21/21] KVM: arm64: Don't constrain maximum IPA size based on host configuration
Date: Tue, 25 Aug 2020 10:39:53 +0100 [thread overview]
Message-ID: <20200825093953.26493-22-will@kernel.org> (raw)
In-Reply-To: <20200825093953.26493-1-will@kernel.org>
Now that the guest stage-2 page-tables are managed independently from
the host stage-1 page-tables, we can avoid constraining the IPA size
based on the host and instead limit it only based on the PARange field
of the ID_AA64MMFR0 register.
Cc: Marc Zyngier <maz@kernel.org>
Cc: Quentin Perret <qperret@google.com>
Signed-off-by: Will Deacon <will@kernel.org>
---
arch/arm64/kvm/reset.c | 38 +++++---------------------------------
1 file changed, 5 insertions(+), 33 deletions(-)
diff --git a/arch/arm64/kvm/reset.c b/arch/arm64/kvm/reset.c
index ee33875c5c2a..471ee9234e40 100644
--- a/arch/arm64/kvm/reset.c
+++ b/arch/arm64/kvm/reset.c
@@ -339,7 +339,7 @@ u32 get_kvm_ipa_limit(void)
int kvm_set_ipa_limit(void)
{
- unsigned int ipa_max, pa_max, va_max, parange, tgran_2;
+ unsigned int parange, tgran_2;
u64 mmfr0;
mmfr0 = read_sanitised_ftr_reg(SYS_ID_AA64MMFR0_EL1);
@@ -376,38 +376,10 @@ int kvm_set_ipa_limit(void)
break;
}
- pa_max = id_aa64mmfr0_parange_to_phys_shift(parange);
-
- /* Clamp the IPA limit to the PA size supported by the kernel */
- ipa_max = (pa_max > PHYS_MASK_SHIFT) ? PHYS_MASK_SHIFT : pa_max;
- /*
- * Since our stage2 table is dependent on the stage1 page table code,
- * we must always honor the following condition:
- *
- * Number of levels in Stage1 >= Number of levels in Stage2.
- *
- * So clamp the ipa limit further down to limit the number of levels.
- * Since we can concatenate upto 16 tables at entry level, we could
- * go upto 4bits above the maximum VA addressable with the current
- * number of levels.
- */
- va_max = PGDIR_SHIFT + PAGE_SHIFT - 3;
- va_max += 4;
-
- if (va_max < ipa_max)
- ipa_max = va_max;
-
- /*
- * If the final limit is lower than the real physical address
- * limit of the CPUs, report the reason.
- */
- if (ipa_max < pa_max)
- pr_info("kvm: Limiting the IPA size due to kernel %s Address limit\n",
- (va_max < pa_max) ? "Virtual" : "Physical");
-
- WARN(ipa_max < KVM_PHYS_SHIFT,
- "KVM IPA limit (%d bit) is smaller than default size\n", ipa_max);
- kvm_ipa_limit = ipa_max;
+ kvm_ipa_limit = id_aa64mmfr0_parange_to_phys_shift(parange);
+ WARN(kvm_ipa_limit < KVM_PHYS_SHIFT,
+ "KVM IPA limit (%d bit) is smaller than default size\n",
+ kvm_ipa_limit);
kvm_info("IPA Size Limit: %dbits\n", kvm_ipa_limit);
return 0;
--
2.28.0.297.g1956fa8f8d-goog
_______________________________________________
kvmarm mailing list
kvmarm@lists.cs.columbia.edu
https://lists.cs.columbia.edu/mailman/listinfo/kvmarm
next prev parent reply other threads:[~2020-08-25 9:40 UTC|newest]
Thread overview: 86+ messages / expand[flat|nested] mbox.gz Atom feed top
2020-08-25 9:39 [PATCH v3 00/21] KVM: arm64: Rewrite page-table code and fault handling Will Deacon
2020-08-25 9:39 ` [PATCH v3 01/21] KVM: arm64: Remove kvm_mmu_free_memory_caches() Will Deacon
2020-08-25 9:39 ` [PATCH v3 02/21] KVM: arm64: Add stand-alone page-table walker infrastructure Will Deacon
2020-08-27 16:27 ` Alexandru Elisei
2020-08-28 15:43 ` Alexandru Elisei
2020-09-02 10:36 ` Will Deacon
2020-08-28 15:51 ` Alexandru Elisei
2020-09-02 10:49 ` Will Deacon
2020-09-02 6:31 ` Gavin Shan
2020-09-02 11:02 ` Will Deacon
2020-09-03 1:11 ` Gavin Shan
2020-08-25 9:39 ` [PATCH v3 03/21] KVM: arm64: Add support for creating kernel-agnostic stage-1 page tables Will Deacon
2020-08-28 15:35 ` Alexandru Elisei
2020-09-02 10:06 ` Will Deacon
2020-08-25 9:39 ` [PATCH v3 04/21] KVM: arm64: Use generic allocator for hyp stage-1 page-tables Will Deacon
2020-08-28 16:32 ` Alexandru Elisei
2020-09-02 11:35 ` Will Deacon
2020-09-02 14:48 ` Alexandru Elisei
2020-08-25 9:39 ` [PATCH v3 05/21] KVM: arm64: Add support for creating kernel-agnostic stage-2 page tables Will Deacon
2020-09-02 6:40 ` Gavin Shan
2020-09-02 11:30 ` Will Deacon
2020-08-25 9:39 ` [PATCH v3 06/21] KVM: arm64: Add support for stage-2 map()/unmap() in generic page-table Will Deacon
2020-09-01 16:24 ` Alexandru Elisei
2020-09-02 11:46 ` Will Deacon
2020-09-03 2:57 ` Gavin Shan
2020-09-03 5:27 ` Gavin Shan
2020-09-03 11:18 ` Gavin Shan
2020-09-03 12:30 ` Will Deacon
2020-09-03 16:15 ` Will Deacon
2020-09-04 0:47 ` Gavin Shan
2020-08-25 9:39 ` [PATCH v3 07/21] KVM: arm64: Convert kvm_phys_addr_ioremap() to generic page-table API Will Deacon
2020-09-01 17:08 ` Alexandru Elisei
2020-09-02 11:48 ` Will Deacon
2020-09-03 3:57 ` Gavin Shan
2020-08-25 9:39 ` [PATCH v3 08/21] KVM: arm64: Convert kvm_set_spte_hva() " Will Deacon
2020-09-02 15:37 ` Alexandru Elisei
2020-09-03 16:37 ` Will Deacon
2020-09-03 4:13 ` Gavin Shan
2020-08-25 9:39 ` [PATCH v3 09/21] KVM: arm64: Convert unmap_stage2_range() " Will Deacon
2020-09-02 16:23 ` Alexandru Elisei
2020-09-02 18:44 ` Alexandru Elisei
2020-09-03 17:57 ` Will Deacon
2020-09-08 13:07 ` Alexandru Elisei
2020-09-09 10:57 ` Alexandru Elisei
2020-09-03 4:19 ` Gavin Shan
2020-08-25 9:39 ` [PATCH v3 10/21] KVM: arm64: Add support for stage-2 page-aging in generic page-table Will Deacon
2020-09-03 4:33 ` Gavin Shan
2020-09-03 16:48 ` Will Deacon
2020-09-04 1:01 ` Gavin Shan
2020-08-25 9:39 ` [PATCH v3 11/21] KVM: arm64: Convert page-aging and access faults to generic page-table API Will Deacon
2020-09-03 4:37 ` Gavin Shan
2020-08-25 9:39 ` [PATCH v3 12/21] KVM: arm64: Add support for stage-2 write-protect in generic page-table Will Deacon
2020-09-03 4:47 ` Gavin Shan
2020-08-25 9:39 ` [PATCH v3 13/21] KVM: arm64: Convert write-protect operation to generic page-table API Will Deacon
2020-09-03 4:48 ` Gavin Shan
2020-08-25 9:39 ` [PATCH v3 14/21] KVM: arm64: Add support for stage-2 cache flushing in generic page-table Will Deacon
2020-09-03 4:51 ` Gavin Shan
2020-08-25 9:39 ` [PATCH v3 15/21] KVM: arm64: Convert memslot cache-flushing code to generic page-table API Will Deacon
2020-09-03 4:52 ` Gavin Shan
2020-08-25 9:39 ` [PATCH v3 16/21] KVM: arm64: Add support for relaxing stage-2 perms in generic page-table code Will Deacon
2020-09-03 4:55 ` Gavin Shan
2020-08-25 9:39 ` [PATCH v3 17/21] KVM: arm64: Convert user_mem_abort() to generic page-table API Will Deacon
2020-09-03 6:05 ` Gavin Shan
2020-08-25 9:39 ` [PATCH v3 18/21] KVM: arm64: Check the pgt instead of the pgd when modifying page-table Will Deacon
2020-09-03 5:00 ` Gavin Shan
2020-08-25 9:39 ` [PATCH v3 19/21] KVM: arm64: Remove unused page-table code Will Deacon
2020-09-03 6:02 ` Gavin Shan
2020-08-25 9:39 ` [PATCH v3 20/21] KVM: arm64: Remove unused 'pgd' field from 'struct kvm_s2_mmu' Will Deacon
2020-09-03 5:07 ` Gavin Shan
2020-09-03 16:50 ` Will Deacon
2020-09-04 0:59 ` Gavin Shan
2020-09-04 10:02 ` Marc Zyngier
2020-08-25 9:39 ` Will Deacon [this message]
2020-09-03 5:09 ` [PATCH v3 21/21] KVM: arm64: Don't constrain maximum IPA size based on host configuration Gavin Shan
2020-08-27 16:26 ` [PATCH v3 00/21] KVM: arm64: Rewrite page-table code and fault handling Alexandru Elisei
2020-09-01 16:15 ` Will Deacon
2020-09-03 7:34 ` Gavin Shan
2020-09-03 11:13 ` Gavin Shan
2020-09-03 11:48 ` Gavin Shan
2020-09-03 12:16 ` Will Deacon
2020-09-04 0:51 ` Gavin Shan
2020-09-04 10:07 ` Marc Zyngier
2020-09-05 3:56 ` Gavin Shan
2020-09-05 9:33 ` Marc Zyngier
2020-09-07 9:27 ` Will Deacon
2020-09-03 18:52 ` Will Deacon
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20200825093953.26493-22-will@kernel.org \
--to=will@kernel.org \
--cc=catalin.marinas@arm.com \
--cc=kernel-team@android.com \
--cc=kvmarm@lists.cs.columbia.edu \
--cc=linux-arm-kernel@lists.infradead.org \
--cc=maz@kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox