Re: [LARTC] CBQ DEVICE BW?

[Srikanth <srikanth_w@naturesoft.net>]

[-- Attachment #1: Type: text/plain, Size: 1125 bytes --]

Thanks Stef,

I need to clarify more please.

Stef Coene wrote:

>On Friday 23 May 2003 10:44, Srikanth wrote:
>  
>
>>Hi,
>>
>>The CBQ config file shud be some thing like this.
>>
>>DEVICE=eth0,10Mbit,1Mbit
>>RATE=50Kbit
>>WEIGHT=5Kbit
>>
>>Shall i hardcode the DEVICE BW as 10/100 Mbit
>>or
>>Shall i use any other tool like ethtool for getting this.
>>ethtool gives Speed: 10Mbps
>>
>>If so, how about, if i use some other Interfaces other than eth0,
>>like ppp0 or some other?
>>
>>C'd anybody can give a suggestion over this?
>>    
>>
>Bandwidth should be the real physical bandwidth of the device.
>
Forgive me, if i'm wrong. 

As of my understanding, are the below lines right?

DEVICE BW = Real physical bandwidth of the device 

So, Here DEVICE means only the Interface, not the Link, am i right?
 
&

RATE = Rate assigned to perticular user/network/service.

How much the user/network/service can aquire max. allowable rate?


I can consider as 10/100 Mbps for ethernet interface.
So, how about, when i use ppp0 (pppoe) in my CBQ, is it same?
bcoz, pppoe uses eth0, am i right?

>
>Stef
>
reg,
Srikanth.

>
>  
>


[-- Attachment #2: Type: text/html, Size: 1701 bytes --]