[LARTC] Problems setting up routing for multiple links

[LARTC] Problems setting up routing for multiple links

[zen30267]

Hi All,

I am trying to setup Routing on my Bering Firewall to allow connections to two providers, as well as maintaining inbound connections to web servers hosted in a dmz.

I have been adding the commands as described on the web site section 4.2.1, but find that the line shown with an * generate a file already exists.

ip route add $P1_NET dev $IF1 src $IP1 table T1
ip route add default via $P1 table T1
ip route add $P2_NET dev $IF2 src $IP2 table T2
ip route add default via $P2 table T2

* ip route add $P1_NET dev $IF1 src $IP1
* ip route add $P2_NET dev $IF2 src $IP2

ip route add default via $P1

ip rule add from $IP1 table T1
ip rule add from $IP2 table T2

ip route add $P0_NET     dev $IF0 table T1
ip route add $P2_NET     dev $IF2 table T1
ip route add 127.0.0.0/8 dev lo   table T1
ip route add $P0_NET     dev $IF0 table T2
ip route add $P1_NET     dev $IF1 table T2
ip route add 127.0.0.0/8 dev lo   table T2 


I am using the up command to add these to the /etc/networks/interface file.

I believe I will need further routes for the dmz, but need to understand the first failure before moving onto this issue. Any help on this would be much appreciated.

Regards,

Simon Chalk.




_______________________________________________
LARTC mailing list / LARTC@mailman.ds9a.nl
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/