adding pxa3xx_nand_flash to platform data

[gores@marvell.com (Siddarth Gore)]

On Thu, 2010-05-06 at 02:20 -0700, Haojian Zhuang wrote:
> On Wed, May 5, 2010 at 4:56 AM, Eric Miao <eric.y.miao@gmail.com> wrote:
> > On Wed, May 5, 2010 at 4:56 PM, Eric Miao <eric.y.miao@gmail.com> wrote:
> >> On Wed, May 5, 2010 at 3:58 PM, Siddarth Gore <gores@marvell.com> wrote:
> >>> Hello Eric,
> >>>
> >>> Currently I need to enable the deprecated MTD_NAND_PXA3xx_BUILTIN
> >>> support for Aspenite DB board (pxa168). I have a patch ready to add
> >>> pxa3xx_nand_flash in aspenite.c but I was wondering about the cmdset
> >>> field in it.
> >>> Looks like it is the same for all boards (depending upon the page size).
> >>> So should I add it to the board specific setup file or remove it from
> >>> pxa3xx_nand_platform_data (and put it in say, pxa3xx_nand_info)?
> >>>
> >>> If there are boards which require a different cmdset then we have to go
> >>> with first option, if not, we can use option two and save some code
> >>> duplication.
> >>>
> >>
> >> There are normally two sets of commands, yet the code derived from some
> >> previous work that there were several subtle different command sets.
> >>
> 
> We already formated the patches of removing the duplication. Now it's
> put into mailist. Try these patches.
> 
Thanks a lot Haojian. I have tried the whole patchset and it is working
fine on my Aspenite DB board. Did not get a chance to check individual
patches though.

Also, some patches did not get applied with git-am. I had to manually
apply them.

-siddarth

> Thanks
> Haojian