* [PATCH 11/25] ARM: cns3xxx: use ehci platform driver
[not found] <1349276601-8371-1-git-send-email-florian@openwrt.org>
@ 2012-10-03 15:03 ` Florian Fainelli
2012-10-03 15:03 ` [PATCH 16/25] ARM: cns3xxx: use OHCI " Florian Fainelli
1 sibling, 0 replies; 2+ messages in thread
From: Florian Fainelli @ 2012-10-03 15:03 UTC (permalink / raw)
To: linux-arm-kernel
Signed-off-by: Florian Fainelli <florian@openwrt.org>
---
arch/arm/mach-cns3xxx/cns3420vb.c | 44 ++++++++++++++++++++++++++++++++++++-
1 file changed, 43 insertions(+), 1 deletion(-)
diff --git a/arch/arm/mach-cns3xxx/cns3420vb.c b/arch/arm/mach-cns3xxx/cns3420vb.c
index 2c5fb4c..906094c 100644
--- a/arch/arm/mach-cns3xxx/cns3420vb.c
+++ b/arch/arm/mach-cns3xxx/cns3420vb.c
@@ -24,6 +24,7 @@
#include <linux/mtd/mtd.h>
#include <linux/mtd/physmap.h>
#include <linux/mtd/partitions.h>
+#include <linux/usb/ehci_pdriver.h>
#include <asm/setup.h>
#include <asm/mach-types.h>
#include <asm/hardware/gic.h>
@@ -32,6 +33,7 @@
#include <asm/mach/time.h>
#include <mach/cns3xxx.h>
#include <mach/irqs.h>
+#include <mach/pm.h>
#include "core.h"
#include "devices.h"
@@ -125,13 +127,53 @@ static struct resource cns3xxx_usb_ehci_resources[] = {
static u64 cns3xxx_usb_ehci_dma_mask = DMA_BIT_MASK(32);
+static int csn3xxx_usb_ehci_power_on(struct platform_device *pdev)
+{
+ /*
+ * EHCI and OHCI share the same clock and power,
+ * resetting twice would cause the 1st controller been reset.
+ * Therefore only do power up at the first up device, and
+ * power down at the last down device.
+ *
+ * Set USB AHB INCR length to 16
+ */
+ if (atomic_inc_return(&usb_pwr_ref) == 1) {
+ cns3xxx_pwr_power_up(1 << PM_PLL_HM_PD_CTRL_REG_OFFSET_PLL_USB);
+ cns3xxx_pwr_clk_en(1 << PM_CLK_GATE_REG_OFFSET_USB_HOST);
+ cns3xxx_pwr_soft_rst(1 << PM_SOFT_RST_REG_OFFST_USB_HOST);
+ __raw_writel((__raw_readl(MISC_CHIP_CONFIG_REG) | (0X2 << 24)),
+ MISC_CHIP_CONFIG_REG);
+ }
+
+ return 0;
+}
+
+static void csn3xxx_usb_ehci_power_off(struct platform_device *pdev)
+{
+ /*
+ * EHCI and OHCI share the same clock and power,
+ * resetting twice would cause the 1st controller been reset.
+ * Therefore only do power up at the first up device, and
+ * power down@the last down device.
+ */
+ if (atomic_dec_return(&usb_pwr_ref) == 0)
+ cns3xxx_pwr_clk_dis(1 << PM_CLK_GATE_REG_OFFSET_USB_HOST);
+}
+
+static struct usb_ehci_pdata cns3xxx_usb_ehci_pdata = {
+ .port_power_off = 1,
+ .power_on = csn3xxx_usb_ehci_power_on,
+ .power_off = csn3xxx_usb_ehci_power_off,
+};
+
static struct platform_device cns3xxx_usb_ehci_device = {
- .name = "cns3xxx-ehci",
+ .name = "ehci-platform",
.num_resources = ARRAY_SIZE(cns3xxx_usb_ehci_resources),
.resource = cns3xxx_usb_ehci_resources,
.dev = {
.dma_mask = &cns3xxx_usb_ehci_dma_mask,
.coherent_dma_mask = DMA_BIT_MASK(32),
+ .platform_data = &cns3xxx_usb_ehci_pdata,
},
};
--
1.7.9.5
^ permalink raw reply related [flat|nested] 2+ messages in thread* [PATCH 16/25] ARM: cns3xxx: use OHCI platform driver
[not found] <1349276601-8371-1-git-send-email-florian@openwrt.org>
2012-10-03 15:03 ` [PATCH 11/25] ARM: cns3xxx: use ehci platform driver Florian Fainelli
@ 2012-10-03 15:03 ` Florian Fainelli
1 sibling, 0 replies; 2+ messages in thread
From: Florian Fainelli @ 2012-10-03 15:03 UTC (permalink / raw)
To: linux-arm-kernel
Since both the EHCI and OHCI platform drivers use the same power_{on,off}
callbacks, rename them to cns3xx_usb_power_{on,off} to show that they are
shared.
Signed-off-by: Florian Fainelli <florian@openwrt.org>
---
arch/arm/mach-cns3xxx/cns3420vb.c | 18 +++++++++++++-----
1 file changed, 13 insertions(+), 5 deletions(-)
diff --git a/arch/arm/mach-cns3xxx/cns3420vb.c b/arch/arm/mach-cns3xxx/cns3420vb.c
index 906094c..8a00cee8 100644
--- a/arch/arm/mach-cns3xxx/cns3420vb.c
+++ b/arch/arm/mach-cns3xxx/cns3420vb.c
@@ -25,6 +25,7 @@
#include <linux/mtd/physmap.h>
#include <linux/mtd/partitions.h>
#include <linux/usb/ehci_pdriver.h>
+#include <linux/usb/ohci_pdriver.h>
#include <asm/setup.h>
#include <asm/mach-types.h>
#include <asm/hardware/gic.h>
@@ -127,7 +128,7 @@ static struct resource cns3xxx_usb_ehci_resources[] = {
static u64 cns3xxx_usb_ehci_dma_mask = DMA_BIT_MASK(32);
-static int csn3xxx_usb_ehci_power_on(struct platform_device *pdev)
+static int csn3xxx_usb_power_on(struct platform_device *pdev)
{
/*
* EHCI and OHCI share the same clock and power,
@@ -148,7 +149,7 @@ static int csn3xxx_usb_ehci_power_on(struct platform_device *pdev)
return 0;
}
-static void csn3xxx_usb_ehci_power_off(struct platform_device *pdev)
+static void csn3xxx_usb_power_off(struct platform_device *pdev)
{
/*
* EHCI and OHCI share the same clock and power,
@@ -162,8 +163,8 @@ static void csn3xxx_usb_ehci_power_off(struct platform_device *pdev)
static struct usb_ehci_pdata cns3xxx_usb_ehci_pdata = {
.port_power_off = 1,
- .power_on = csn3xxx_usb_ehci_power_on,
- .power_off = csn3xxx_usb_ehci_power_off,
+ .power_on = csn3xxx_usb_power_on,
+ .power_off = csn3xxx_usb_power_off,
};
static struct platform_device cns3xxx_usb_ehci_device = {
@@ -191,13 +192,20 @@ static struct resource cns3xxx_usb_ohci_resources[] = {
static u64 cns3xxx_usb_ohci_dma_mask = DMA_BIT_MASK(32);
+static struct usb_ohci_pdata cns3xxx_usb_ohci_pdata = {
+ .num_ports = 1,
+ .power_on = csn3xxx_usb_power_on,
+ .power_off = csn3xxx_usb_power_off,
+};
+
static struct platform_device cns3xxx_usb_ohci_device = {
- .name = "cns3xxx-ohci",
+ .name = "ohci-platform",
.num_resources = ARRAY_SIZE(cns3xxx_usb_ohci_resources),
.resource = cns3xxx_usb_ohci_resources,
.dev = {
.dma_mask = &cns3xxx_usb_ohci_dma_mask,
.coherent_dma_mask = DMA_BIT_MASK(32),
+ .platform_data = &cns3xxx_usb_ohci_pdata,
},
};
--
1.7.9.5
^ permalink raw reply related [flat|nested] 2+ messages in thread