Re: [PATCH v3 0/7] usb: typec: ucsi: rework glue driver interface

[Greg Kroah-Hartman <gregkh@linuxfoundation.org>]

On Tue, Jun 25, 2024 at 05:54:25PM +0300, Dmitry Baryshkov wrote:
> The interface between UCSI and the glue driver is very low-level. It
> allows reading the UCSI data from any offset (but in reality the UCSI
> driver reads only VERSION, CCI an MESSAGE_IN data). All event handling
> is to be done by the glue driver (which already resulted in several
> similar-but-slightly different implementations). It leaves no place to
> optimize the write-read-read sequence for the command execution (which
> might be beneficial for some of the drivers), etc.
> 
> The patchseries attempts to restructure the UCSI glue driver interface
> in order to provide sensible operations instead of a low-level read /
> write calls.
> 
> If this approach is found to be acceptable, I plan to further rework the
> command interface, moving reading CCI and MESSAGE_IN to the common
> control code, which should simplify driver's implementation and remove
> necessity to split quirks between sync_control and read_message_in e.g.
> as implemented in the ucsi_ccg.c.
> 
> Note, the series was tested only on the ucsi_glink platforms. Further
> testing is appreciated.
> 
> Depends: [1], [2]
> 
> [1] https://lore.kernel.org/linux-usb/20240612124656.2305603-1-fabrice.gasnier@foss.st.com/
> 
> [2] https://lore.kernel.org/linux-usb/20240621-ucsi-yoga-ec-driver-v8-1-e03f3536b8c6@linaro.org/
> 
> Signed-off-by: Dmitry Baryshkov <dmitry.baryshkov@linaro.org>

This doesn't apply to my tree at all, can you rebase and add Heikki's
review and resend?

thanks,

greg k-h