[PATCH 0/4] Dongwoon DW9714 - correct vcc/vdd supply voltage

[David Heidelberg via B4 Relay <devnull+david.ixit.cz@kernel.org>]

So much mess, as people defines 1.8V i2c level shifters instead of VDD.

I don't pocess any of these devices, so please test carefully,
you may need to in addition to this change put regulator-always-on to
the 1.8V which was previously abused instead of VDD. Careful about
combination when camera which pulls in 1.8V (usually iovdd) as a byproduct
takes care of i2c supply for the coil.

Signed-off-by: David Heidelberg <david@ixit.cz>
---
David Heidelberg (4):
      media: dt-bindings: dongwoon,dw9714: Example shouldn't imply 1.8 V
      arm64: dts: rockchip: rk3399-pinephone-pro: DW9714 coil requires higher voltage
      arm64: dts: rockchip: rk3566-pinetab2: DW9714 coil requires higher voltage
      arm64: dts: imx8mq-librem5: Dongwoon DW9714 coil requires higher voltage

 Documentation/devicetree/bindings/media/i2c/dongwoon,dw9714.yaml | 4 ++--
 arch/arm64/boot/dts/freescale/imx8mq-librem5.dtsi                | 2 +-
 arch/arm64/boot/dts/rockchip/rk3399-pinephone-pro.dts            | 2 +-
 arch/arm64/boot/dts/rockchip/rk3566-pinetab2.dtsi                | 2 +-
 4 files changed, 5 insertions(+), 5 deletions(-)
---
base-commit: 95d6a9ccef99117115e41e9adb271243bd5e985b
change-id: 20260801-pp-pro-camera-a14d1af483cd

Best regards,
--  
David Heidelberg <david@ixit.cz>