[PATCH v2 02/10] dt-bindings: phy: rockchip: naneng-combphy: add rockchip,sgmii-mac-sel property

[Coia Prant <coiaprant@gmail.com>]

On RK3568, the SGMII interface can be routed to either GMAC0 or
GMAC1 via the pipe_sgmii_mac_sel bit in the pipe GRF registers.

Add the optional "rockchip,sgmii-mac-sel" property to allow the
device tree to select which GMAC controller is used for SGMII.

The property takes a value of 0 (GMAC0) or 1 (GMAC1). The hardware
reset value is 1 (GMAC1), but this can be overridden by setting the
property to 0 for boards where SGMII is connected to GMAC0.

This is necessary for boards such as the Ariaboard Photonicat, where
the SGMII interface is connected to GMAC0 and needs to be explicitly
configured.

Signed-off-by: Coia Prant <coiaprant@gmail.com>
---
 .../bindings/phy/phy-rockchip-naneng-combphy.yaml   | 13 +++++++++++++
 1 file changed, 13 insertions(+)

diff --git a/Documentation/devicetree/bindings/phy/phy-rockchip-naneng-combphy.yaml b/Documentation/devicetree/bindings/phy/phy-rockchip-naneng-combphy.yaml
index 379b08bd9e97a..8e898bce9af73 100644
--- a/Documentation/devicetree/bindings/phy/phy-rockchip-naneng-combphy.yaml
+++ b/Documentation/devicetree/bindings/phy/phy-rockchip-naneng-combphy.yaml
@@ -80,6 +80,15 @@ properties:
     description:
       Some additional pipe settings are accessed through GRF regs.
 
+  rockchip,sgmii-mac-sel:
+    $ref: /schemas/types.yaml#/definitions/uint32
+    enum: [0, 1]
+    default: 1
+    description:
+      Select gmac0 or gmac1 to be used as SGMII controller.
+      The hardware reset value is GMAC1 (1). Set this to 0 to route
+      SGMII to GMAC0.
+
   "#phy-cells":
     const: 1
 
@@ -105,6 +114,10 @@ allOf:
           maxItems: 1
         reset-names:
           maxItems: 1
+        rockchip,sgmii-mac-sel: true
+    else:
+      properties:
+        rockchip,sgmii-mac-sel: false
   - if:
       properties:
         compatible:
-- 
2.47.3